DeRoyal M2200-WHL Quick Start Instructions

M2200 Chair Belt Sensor
WARNING: Failure to comply with warning may result in injury or death. This device is not suitable for all individuals. Other devices may be required.
This device is not a substitute for visual monitoring by caregiver. The manufacturer does not claim that this device will stop elopement and/or stop falls.
This device is designed to augment caregivers' comprehensive resident mobility management program.
TO RESTRAIN OR HOLD INDIVIDUALS IN POSITION IN THEIR CHAIRS. Test this device before each use. Read the
instructions and Legal Disclaimer.
The DeRoyal M2200-WCB Wheel Chair Belt is designed to be installed by the end user. As such, it is the entire responsibility of the buyer to insure that the
system is properly installed and tested. Further, the system is not designed to replace good caregiving practices including, but not limited to:
A.) Direct patient supervision
B.) Adequate training for staff personnel for fall prevention and elopement
C.) Testing of the system before each use
WHERE PERMISSIBLE, IT IS THE SELLER'S INTENT TO LIMIT ANY LIABILITY FOR SPECIAL, CONSEQUENTIAL OR INCIDENTAL ECONOMIC DAMAGES TO REFUND
OF THE PURCHASE PRICE OR REPLACEMENT OF THE GOODS. SELLER DISCLAIMS ANY LIABILITY FOR COMPENSATORY OR OTHER DAMAGES ARISING OUT OF
THE USE OF THE GOODS.
WARNING: The manufacturer does not claim that this device will stop elopement and/or stop falls. This device is designed to augment caregivers'
comprehensive resident mobility management program. This product is to be used by a licensed caregiver only.
Limited Warranty: Seller warrants that the goods sold will be free from defects of workmanship and manufacturing, for a period of one year from the
date of sale. Other than this limited warranty, seller makes no express or implied warranties. Except for this limited warranty, NO EXPRESS OR IMPLIED
WARRANTIES ARE GIVEN AND NO AFFIRMATION OF SELLER, BY WORDS OR ACTION, WILL CONSTITUTE A WARRANTY. THE GOODS BEING PURCHASED ARE
BEING SOLD ON A "WITH ALL FAULTS" BASIS. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE GOODS IS WITH THE BUYER. SHOULD THE
GOODS PROVE DEFECTIVE FOLLOWING THEIR PURCHASE, THE BUYER, AND NOT THE MANUFACTURER, DISTRIBUTOR OR RETAILER, ASSUMES THE ENTIRE
COST OF ALL NECESSARY INSTALLATION, SERVICING OR REPAIRS.
DeRoyal, DeRoyal logo, Improving Care. Improving Business.,
are registered trademarks of DeRoyal Industries, Inc.
Caregiver Key, Safety Auto-Reset are trademarks of The Smart
Caregiver Corporation.
Copyright© 2018, DeRoyal. All rights reserved.
THIS DEVICE IS NOT DESIGNED
DeRoyal Industries | 200 DeBusk Lane | Powell, TN 37849
888.938.7828 | 865.938.7828 | www.deroyal.com
Rev 1/18 | Part # 0-1926
BELT PLACEMENT
• Place belt on patient's lap with the blue hook and loop
closure in the front and center of patient.
• Wrap the belt around the patient and behind the
wheelchair or recliner.
• Refer to step 2 for belt installation.
• Connect a belt cord to the monitor.
• Place the monitor out of reach of the patient. Suitable
mounting locations include the back of wheelchair, or
on the chair handle so that the patient cannot tamper
with the monitor.
TEST THE SYSTEM
• Engage and disengage the hook and loop closure to set
off the alert. The monitor is now active. The alert will
sound whenever the hook and loop is disengaged.
• When the alert is activated, press the "Reset" button
on front of the monitor to silence the alert or use the
Caregiver Key, depending on your reset setting. The
status light on front of monitor will blink when the belt
is plugged into the monitor and buckled.
Need Set-up Help? (800) 650-3637