Advertisement
Quick Links
Manufactured by
Delichon Limited
1 The Clayfields
Sandleheath Industrial Estate
Old Brickyard Road
Fordingbridge
Hampshire
SP6 1PA
UK
e-mail: office@delichon.uk
Website: www.delichon.uk
Tel. +44 (0)1725 519 405
EU Authorised Representative
Delichon Europe Ltd
Century House
Harold's Cross
Dublin 6W
Dublin
Ireland
e-mail: eu@deltabuggy.com
Your Delta Buggy has a unique serial
number, which can be found on a silver
label on the rear axle – please quote this
number when contacting Delichon about
your buggy.
If a Delta is to be disposed of all
components and materials must be
recycled or disposed of correctly, in
accordance with national regulations.
.8
Pg
Advertisement
Summary of Contents for Delichon Delta Trail
- Page 1 Your Delta Buggy has a unique serial number, which can be found on a silver label on the rear axle – please quote this number when contacting Delichon about your buggy. If a Delta is to be disposed of all...
- Page 2 DELTA TRAIL INSTRUCTION MANUAL PLEASE READ BEFORE USING YOUR DELTA TRAIL AND KEEP IN A SAFE PLACE FOR FUTURE REFERENCE...
-
Page 3: Important Safety Notes
DESCRIPTION The Delta Trail is designed as an accessory to the Delichon Delta Buggy and should not be used with any other product. The Delta Trail allows the Delta Buggy to be towed behind a bicycle. IMPORTANT SAFETY NOTES ♦ CYCLING WITH A TRAILER, AND CYCLING IN GENERAL CAN BE HAZARDOUS. - Page 4 Tether around Retaining pin bracket of Delta frame Clamping lever Tether to cycle frame Retaining pin with nylon spacer ♦ TETHER THE TOW BAR TO THE CYCLE FRAME AND THE DELTA FRAME. ♦ MAKE SURE THAT ALL OF THE RETAINING PINS ARE SECURE AND THE CLAMPS TIGHT.
-
Page 5: Adjusting The Tow Bar
ADJUSTING THE TOW BAR Slide the bottom end of the tow bar into the trail bracket on the Delta. Secure the tow bar to the Delta with the retaining pin that has a nylon spacer. Loop the bungee cord over the end of the pin to keep it in place. Slot the hinge block on the end of the tow bar into the tow hitch on the saddle post and secure with the 8mm retaining pin. - Page 6 ♦ Make sure that your bicycle brakes are in excellent working order. ♦ Make sure children do not bounce or lean while towing, the weight shift could tip the trailer. ♦ Set the park brakes when transferring children in or out.
- Page 7 FITTING THE ROLL-BAR 1. Remove screw from here 1. Remove the uppermost handle fixing screw from one of the handle plates; you will need a 4mm hexagon key and a 10mm spanner. 2. Attach the roll bar bracket to the handle plate as shown. The 20mm screw goes into an inset on the handle plate.
- Page 8 TO THE BICYCLE Attach the tow hitch bracket to the saddle post. You will need a 4mm Saddle Post hexagon key and a 10mm spanner. Two sets of screws are provided; use the length most suited to your saddle post; the ends of the screws need to protrude slightly from the nuts.
Need help?
Do you have a question about the Delta Trail and is the answer not in the manual?
Questions and answers