Let’s get started This quick start guide explains the basic operation of the Range Extender Battery. This guide is also available online in your language. Use the code or link below to access the online guide. You should read this guide completely, as well as the comprehensive Hyena Electric Bicycle Owner’s manual, found online at: trekbikes.com/manuals •...
Parts list 1 Battery 2 Mounting plate 3 Adapter 4 Mounting bolts & washers Install the mounting plate Use the two bolts and washers supplied with the range extender to attach the mounting plate. WARNING: Use only the bolts supplied with the battery (M5x12mm).
Install and remove the battery (physical connection) Install Remove Make sure the battery is firmly attached. Plug the cable into the charg- ing port (electrical connection) IMPORTANT: When the extender battery is physically attached to the bike, it must also be electrically attached to the bike.
Page 5
Charge the battery (continued) WARNING: When charging the battery on the bike, the extender battery must be electrically connected to the bike (page 4). If not, an electric shock or fall hazard may result. 1. Open the cover on the bottom of the extender battery.
Page 6
CH-8600 Dubendorf 9 Sherbourne Drive, Tilbrook, Switzerland Milton Keynes, MK7 8HX Tel.: 00800 8735 8735 Tel.: +44 1908 360 140 Australia & New Zealand Trek Australia & New Zealand Customer Service PO Box 1747 Fyshwick, ACT2609 Australia customerservice_australia@trekbikes.com customerservice_newzealand@trekbikes.com EN-5...
Need help?
Do you have a question about the Hyena Range Extender and is the answer not in the manual?
Questions and answers
trouble shooting charging issues