MAYTONI PSL-DL40-S-150-300mA-DE Operating Manual

Operating Manual
Selection and Connection
of DALI DT6 LED Drivers
2. Selecting an LED Driver
Driver selection should be based on the LED's technical specifications as
provided by the LED manufacturer. When replacing a non-dimmable driver
with a DALI DT6 dimmable driver, the technical characteristics of the
dimmable driver must match those of the non-dimmable driver. Pay attention
to the driver's output characteristics (OUTPUT or SEC), specifically:
- Current (measured in mA)
- Voltage range (measured in V)
The current of the dimmable driver must not exceed the current rating of the non-dimmable driver, and the voltage
range should match.
Only a qualified technician should select the appropriate driver.
3. Replacing an LED Driver
To replace a non-dimmable driver with a DALI DT6 dimmable driver, disconnect the fixture from the power supply and
detach it from the non-dimmable driver by removing the driver cover and extracting wires from the terminals. Connect
the DALI DT6 dimmable driver in reverse order. If the non-dimmable driver is non-dismantlable, wires may be clipped
with wire cutters or a specialized tool. The DALI DT6 dimmable driver should then be connected to the lighting fixture
using soldered wires or special terminals and a DALI DT6 control unit (see diagrams 1, 2, 3).
Replacement must be performed by a qualified specialist.
4. Key Technical Specifications
Model Number
Input Voltage, V
Network Frequency, Hz
Power Factor
Max. Output Power, W
Output Voltage Range, V
Output Current, mA
Current Adjustment
Efficiency, %
Protection Class
IP Rating
Dimming
Color Temperature Adjustment
Control Protocol
Dimming Range, %
Ripple Coefficient, %
Operating Temperature Range (ta), °C
Max. Housing Temperature (tc), °C
Dimensions (L*W*H), mm
Weight, g
5. Contents
1. Driver
2. Operating Manual
6. LED Driver Placement
Place the driver in proximity to the
lighting fixture.
1. Overview and Purpose of LED Drivers
An LED driver operates from a 230V/50Hz mains voltage, providing a
constant current and voltage within a specific range at the output, effectively
functioning as a current stabilizer.
Do not confuse a driver with a power supply!*
Drivers are available in constant current and multi-current types. Multi-current
drivers feature a DIP switch on the housing, allowing output current
adjustments to connect LEDs with different current characteristics or multiple
LEDs in parallel.
DT6 (Device Tape 6) is designed for managing all LED fixtures without
adjustable color temperature.
PSL-DL40-S-150-300mA-DE
АС100-240
50/60
0.9
12
23-40
150/200/250/300
Yes
80
II
IP20
Yes
No
DALI
0.1-100
5
-20...+45
65
131*30*20
58
Note:
For installations involving multiple drivers, it is recommended to space them at
least 200 mm apart and ensure at least 200 mm of free space around each
unit for natural ventilation. Use forced ventilation if free space is limited.
Warning:
Disconnect the power supply before starting to avoid electric shock.
* Warning! A power supply serves
as a voltage stabilizer and is not
suitable for individual LEDs without a
current-limiting resistor, such as with
LED strip lights.
PSL-DL40-S-350-500mA-DE
АС100-240
50/60
0.9
20
23-40
350/400/450/500
Yes
80
II
IP20
Yes
No
DALI
0.1-100
5
-20...+45
65
152*39*30
100