Advertisement
Quick Links
Caliper Covers
Quick Installa�on Guide
MGP Caliper Cover
TOOLS REQUIRED
- 3/8 wrench
- .013 feeler gauge
(or included .013 paper strip)
IMPORTANT
Clip baggies marked FRONT & REAR.
-
Keep separate.
- Space between wheel and face of
caliper must be 1/8" min.
1
SA Clip
Lock Nuts
2
MGP Caliper Cover
SA Clip
Remove lock nuts from
snap clips.
3
Lock Nuts
Slide the stainless steel clips on each side of the brake
caliper bracket. Fit should be snug and secure.
Place one bridge over stud and stretch 2nd bridge over stud.
B
Install the supplied lock nuts
onto the threaded studs to
secure clip to bridge. Tighten
with 3/8-inch wrench or
socket to 25 in pounds. Do
not over�ghten nuts.
Advertisement
Summary of Contents for MGP CaliperCovers 20227S
- Page 1 Slide the stainless steel clips on each side of the brake SA Clip caliper bracket. Fit should be snug and secure. Lock Nuts MGP Caliper Cover Place one bridge over stud and stretch 2nd bridge over stud. MGP Caliper Cover SA Clip...
- Page 2 Troubleshoo�ng Guide Need Help? IMPORTANT! Use feeler gauge or the Email • TECH@CALIPERCOVERS.COM included paper strip to Tech Support • 1.877.995.0003 - Op�on 2 check clearance between clip and brake rotor. A gap Scan the QR code for the of at least .013 inch (.32 mm) is recommended installa�on instruc�ons video (enough to slide the paper...
Need help?
Do you have a question about the CaliperCovers 20227S and is the answer not in the manual?
Questions and answers