17. ENVIRONMENTAL CONCERNS................53 DEAR CUSTOMER Thank you for choosing this Husqvarna-Electrolux product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler – features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it.
ENGLISH SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.
This appliance is intended to be used in household • and similar applications such as: staff kitchen areas in shops, offices and other – working environments; by clients in hotels, motels, bed & breakfast and – other residential type environments;...
ENGLISH future they must be reattached to lock be replaced, this must be carried out the drum to prevent an internal by our Authorised Service Centre. damage. • Connect the mains plug to the mains • Always take care when moving the socket only at the end of the appliance as it is heavy.
• Do not wash fabrics which are heavily hinge and seals, other seals, door soiled with oil, grease or other greasy locking assembly, plastic peripherals substances. It can damage rubber such as detergent dispensers. Please parts of the washing machine.
ENGLISH • The Intensive option pre-treats effectiveness of washing stubborn stains optimizing the performance. 3.2 Appliance overview 11 12 Worktop Feet for levelling the appliance Detergent dispenser with AutoDose Drain hose tanks and manual compartments Inlet hose connection Control panel Mains cable Door handle Transit bolts...
Level of protection against ingress of solid particles and IPX4 moisture ensured by the protective cover, except where the low voltage equipment has no protection against mois‐ ture Water supply pressure Minimum 0.5 bar (0.05 MPa) Maximum 8 bar (0.8 MPa)
ENGLISH 5. Carefully put the appliance down on It is possible to see its rear side. water flowing from the 6. Put the front polystyrene packaging drain hose. This is due element on the floor under the to the testing with water appliance.
Make sure that carpets do not stop the air circulation below the appliance. Make sure that the appliance does not touch the wall or other units. 2. Loosen or tighten the feet to adjust the level. WARNING! Do not put cardboard, wood 5.3 The inlet hose...
ENGLISH CAUTION! Make sure that there are no leaks from the couplings. Do not use an extension hose if the inlet hose is too short. Contact the service centre for the replacement of the inlet hose. 2. On the edge of a sink - Fasten the guide to the water tap or to the wall.
6. ACCESSORIES 6.1 Available in or from Only appropriate authorised dealer accessories approved by HUSQVARNA ensure the Read carefully the instructions supplied safety standards of the with the accessory. appliance. If unapproved parts are used, any claims...
If you install the appliance on a plinth under the washing machine. that is not an accessory supplied by Verify the compatible HUSQVARNA, secure the appliance in stacking kit by checking the the fixing plates. depth of your appliances. Read carefully the instructions supplied with the accessory.
Page 14
The options are not selectable with all washing programmes. Check the compatibility between options and washing programmes in the "AutoDose and options compatibility with programmes" paragraph in the "Programmes" chapter. An option can exclude another one, in this case the appliance doesn't allow you to set the incompatible options together.
Page 15
ENGLISH Press this button repeatedly to activate one of the two options or both. The relevant indicator comes on. • Intensive By setting this option, the indicator appears close to deter‐ gent symbol, and the appliance will automatically dose an ex‐ tra amount of detergent when automatic detergent tank is ena‐...
Page 16
This option adds a steam phase followed by a short anti-crease phase at the end of the washing programme. The steam phase reduces fabric creasing and facilitates the fabric ironing. The indicator flashes on the display during steam phase.
Page 17
ENGLISH By means of Spin touch button, you can also set: • Drain Only Activate the drain-only option (Skipping the wash, rinse and spin phases): The appliance performs the only draining phase of the selec‐ ted washing programme. The display shows the indicator (cold), the indicator (no spin) and the indicator •...
Page 18
With this option you can prevent that the children play with the control panel. To activate/deactivate this option, touch the Intesive/Prewash and the Time Save buttons simultaneously until the in‐ dicator comes on/goes off on the display. You can activate this option: Child Lock •...
Page 19
ENGLISH Door locked indicator. Child safety lock indicator. The digital indicator can show: • Maximum load indicator: e.g. Cottons . The icon flashes dur‐ ing laundry load estimation. Refer to "ProSense load detection" para‐ graph. • Programme duration: e. g. •...
AutoDose softener tank indicator. When it lights, appliance automatically doses the softener. AutoDose status indicator. It lights when AutoDose function for additives is disable. 7.3 Multilingual badges Adhesive badges in different languages are supplied with the appliance. The desired badge can be glued next to the programme dial.
Page 21
ENGLISH programme, proceed by manually filling AutoDose detergent tank. the product in the proper compartment. AutoDose fabric softener tank. AutoDose The appliance is pre-set by the factory to suit most users habits. Once started the programme, the Manual appliance will automatically release the right amount of detergent and softener according to the real fabric load, if the indicators...
Page 22
'AutoDose configuration mode' how to • Maximum level for detergent/ change the basic setting, but before: additives quantity. 1. Identify the water hardness level. 9.3 AutoDose basic setting Check the water hardness level in your area. The levels are generally The factory pre-set doses for a large indicated as: soft, medium and hard.
Page 23
ENGLISH 9.5 Filling the detergent and additives on AutoDose system Please read "Detergents and other treatments" in "Hints and tips" chapter. We recommend that you do not exceed the maximum indicated level ( 4. Touch related tank buttons to toggle 1.
Page 24
4. Gently pour only liquid softener in the 9.6 AutoDose low level AutoDose fabric softener tank . Fill indication up to the maximum indicated level Do not refill the AutoDose tanks unless appliances indicates that one or both tanks are empty.
Page 25
ENGLISH 9.7 Switching from AutoDose to manual dosing It is possible to disable AutoDose function for one or both tanks by pressing related button symbol. Example: • To switch Fabric Softener tank off, 2. After about 10 seconds the display press the button until the display returns to the programme information...
Page 26
2. Pour the liquid detergent in the 3. If desired, pour the fabric softener in compartment the compartment Manual 3. Gently close the detergent dispenser, 4. Gently close the detergent dispenser, till click engagement. till click engagement. If the machine has not been...
ENGLISH This will happen even if the user turned To restart the programme, ensure the AutoDose off. drawer is properly closed and press Start/Pause button. 10. PROGRAMMES 10.1 Programme Chart Washing programmes Programme Programme description Washing programmes White cotton and coloured cotton. Normally, heavily and lightly soiled items.
Page 28
Programme Programme description Do not use fabric softener and make sure that Outdoor there is no softener residue in the detergent dispenser. Outdoor clothing, technical, sport fabrics, waterproof and breathable jackets, shell jackets with a removable fleece or inner insulation. The recommended laundry load is 2.5 kg.
Page 29
ENGLISH Programme temperature, maximum spin speed and maximum load Programme Default tempera‐ Reference spin Maximum load ture speed Temperature Spin speed range range Washing programmes 1400 rpm 9 kg 40 °C 1400 rpm - 400 rpm Eco 40-60 40 °C 1400 rpm 9 kg 95 °C - Cold...
ENGLISH ■ ■ ■ ■ Plus Steam 1) This option is not available with temperature lower than 40 °C. 2) If you set the shortest duration, we recommend that you decrease the load size. It is possible to fully load the appliance, however the washing results can be less satisfactory. 3) This option is not available with temperature lower than 40 °C.
11. DAILY USE WARNING! CAUTION! Refer to Safety chapters. Washing heavily oiled, greasy stains could cause damage rubber parts of the 11.1 Activating the appliance washing machine. 1. Connect the mains plug to the mains socket. 11.3 Using detergent and 2.
ENGLISH display and the given information 2. Touch the Delay Start button changes accordingly. repeatedly until the display shows In case a selection is not 3. Touch the Start/Pause button possible, no indicator again to start the programme comes on and an acoustic immediately.
If you select the Plus Steam the steam steady on and the indicator phase indicators come on. flashing in the display. In this case, for 30 seconds, it is possible The steam phase is running: to pause the appliance and remove the exceeding garments.
ENGLISH 11.11 Opening the door - When you activate the Adding garments appliance again, the display show the end of the last selected programme. Turn the programme dial to set a While a programme or the delay start new cycle. operates, the appliance door is locked.
• After 5 minutes from the end of the In any case, the appliance washing programme empties the water out Press the On/Off button to activate automatically after the appliance again. approximately 18 hours. The display shows the end of the last set programme.
ENGLISH Special stain removers are available. • When using detergent tabs or pods, Use the special stain remover that is always put them inside the drum, not applicable to the type of stain and fabric. in the detergent dispenser. Insufficient detergent may cause: Do not spray stain remover on garments •...
Use the correct quantity of water softener. Follow the instructions that you find on the packaging of the product. 13. CARE AND CLEANING Remove any foreign objects (such as WARNING! metal clip, buttons, coins, etc) that you Refer to Safety chapters.
ENGLISH 13.5 Maintenance wash Clean the drum with special products for stainless steel. The repeated and prolonged use of low Always follow the temperature and short programmes can instructions that you find on cause detergent deposits, fluff residues, the packaging of the bacterial growth and biofilm formation product.
Page 40
1. Open the detergent dispenser. Press the catch as indicated in the picture and pull the detergent dispenser out. 4. Press the catch on the back as indicated in the picture and lift up the top cover to remove it.
Page 41
ENGLISH CAUTION! Do not use sharp or metal brushes and sponges. 6. Turn the dispenser up side down and open the bottom cover as indicated in the picture. WARNING! Do not clean with any sharp and metal brushes 7. Make sure that all detergent residue ora any tools, pumps or is removed from the conveyor.
To restore the functionality, refill tanks with detergent and softener. If you place a wrong additives in the tanks, you can easily recover it by using the drain plug on both side of the drawer. Before opening drain plugs ensure...
Page 43
ENGLISH Proceed as follows to clean the pump: 6. Repeat the steps 4 and 5 until the water stops to flow out. 1. Open the pump cover. 7. Turn the filter anti-clockwise to remove it. 2. Place a suitable bowl below the drain pump access to collect the water that 8.
2. Remove the inlet hose from the appliance by loosening the ring nut. 12. Close the pump cover. 3. Clean the valve filter on the back of the appliance with a toothbrush. When you drain the water with the...
ENGLISH 1. Put 2 litres of water in the main wash 3. Put the two ends of the inlet hose in compartment of the detergent a container and let the water flow out dispenser. of the hose. 2. Start the programme to drain the 4.
Page 46
• Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. The appliance does For this information, contact your local water authority. not fill with water prop‐...
Page 47
ENGLISH Problem Possible solution • Make sure that the mains plug is connected to the mains socket. • Make sure that the appliance door is closed. • Make sure that there is no damaged fuse in the fuse box. The programme does •...
Problem Possible solution • Increase the detergent quantity or use a different detergent. • Use special products to remove the stubborn stains before you wash the laundry. • Make sure that you set the correct temperature. • Decrease the laundry load.
ENGLISH 3. Open the filter flap. 5. Take out the laundry and then close 4. Pull the emergency unlock trigger the appliance door. downward once. Pull it downward 6. Close the filter flap. once again, keep it tensed and, in the meanwhile, open the appliance door.
Page 50
Values and programme duration may differ depending on different conditions (e.g. room temperature, water temperature and pressure, load size and type of laundry, supply voltage) and also if you change the default setting of a programme. 15.3 According to...
ENGLISH Programme Litres h:mm °C Wool 0.30 1:05 1200 30°C 1) Reference indicator of the spin speed. 2) Suitable for washing heavily soiled textiles. 3) Suitable for washing lightly soiled cottons, synthetic and mixed fabrics. 4) It also performs as quick washing cycle for lightly soiled laundry. 16.
16.2 Cleaning the drain pump filter 180˚ Clean the filter regularly and, especially, if the alarm code appears on the display. 16.3 Programmes Programmes Load Product description White and coloured cottons. Normally soiled 9 kg garments. Eco 40-60 9 kg White cotton and coloured cotton.
ENGLISH Programmes Load Product description White cotton items. This program removes 9 kg more than 99,99% of bacteria and viruses . It Anti-Allergy also ensure a proper reduction of allergens. 1) Washing programme. 2) Washing programme and waterproofing phase. 3) Tested for Staphylococcus aureus, Enterococcus faecium, Candida albicans, Pseudomonas aerugino‐ sa and MS2 Bacteriophage in external test performed by Swissatest Testmaterialien AG in 2021 (Test Report No.
Need help?
Do you have a question about the QW47B914AD and is the answer not in the manual?
Questions and answers