Summary of Contents for PROREGAL RST328
- Page 1 Styroporschneider Heißdrahtschneider Produktnummer: RST328 Hergestellt für Procommerce Group GmbH - Am Kreutweg 1 - 97204 Höchberg - Germany...
- Page 2 ENGLISH INTENDED USE This appliance is designed for cutting product made of plastic, foam, sponge. Use the device only for prescribed purposes. Any other use is considered as an instance of misuse. The user / operator and not the manufacturer will be responsible for any damage or injury caused by such misuse. Remember that this device has not been designed for commercial or industrial use.
-
Page 3: Personal Safety
- Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or moving parts. Damaged or entangled cords increase the risk of electric shock - When operating a power tool outdoors, use an extension cord suitable for outdoor use. Use of a cord suitable for outdoor use reduces the risk of electric shock - If operating a power tool in a damp location is unavoidable, use a residual current device (RCD) protected supply. -
Page 4: Maintenance And Cleaning
OPERATING 1. Preset the cutting blade length. The graduation on the bracket indicates the cutting length. 2. Plug the Power Cord Plug into a suitable volt, grounded, electrical outlet. 3. Turn on the Power Switch to heat up the Blade. The Blade will reach the pre-set operating temperature in several minutes and will remain at the temperature selected. -
Page 5: Symbol Explanation
INTENDED USE Expanded Polystyrene (EPS), Extruded Polystyrene (XPS), Polyethylene, Cross-Linked, Polyethylene, Polypropylenes, and many other foamed plastics and materials can be easily cut with Hot Knife. Use the device only for its intended purpose. Any other use is considered a case of misuse. The user / operator and not the manufacturer will be responsible for any damage or injury caused by this misuse. -
Page 6: Safety Instructions
DUCT DESCRIPTION SAFETY INSTRUCTIONS - WARNING! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. 1) WORK AREA SAFETY: - Keep work area clean and well lit. Cluttered or dark areas invite accidents. - Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. -
Page 7: Operation
- Use personal protective equipment. Always wear eye protection. Protective equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. - Prevent unintentional starting. Ensure the switch is in the off-position before connecting to power source and/or battery pack, picking up or carrying the tool. - Page 8 CAUTION: The blade has a sharpened razor edge, for the cleanest cut always cut in the direction on the sharpened edge. 1. Loosen the screws on the blade holders with the wrench. 2. Slide the blade under the square pressure plate until snug. 3.
-
Page 9: Enviromental Protection
CAUTION: Do not leave the device turned on for too long. The high temperature could buckle the plastic and injure the operator. It is recommended after about three minutes to turn off the device for at least 30 seconds. NOTE: For the best results, first do a test cut. CAUTION: - Consult foam manufacturer's MSDS sheet for flash points and toxicity of material to be cut. - Page 10 and help prevent potential negative impacts on the environment and human health, which could be the consequences of improper disposal of waste. Please contact your local authority or nearest collection point for further details. Incorrect disposal of this type of waste may be subject to fines in accordance with national regulations.
Need help?
Do you have a question about the RST328 and is the answer not in the manual?
Questions and answers