Danny's Desks and Chairs PDAP-PH Assembly Instructions

Assembly Instructions:
Product Code : PDAP-PH
Product Name: Dapper Pigeon Hole Unit
Time Required:
30 minutes
Tools Required:
Screwdriver, Electric Drill, Pencil, Measuring tape/Ruler
*Tools are not included.
Skill Required:
Easy
The Assembly Skill Rating is a 5-point system that shows the degree of effort needed in assembling
a specific product. With 1 being easy for the average person and 5 requiring an expert.
For most products, two persons are recommended.
• As this is a commercial product, some intermediate skills may be required.
• If you are missing any hardware, please contact your Danny reseller. Please ensure you have the name of the item,
• Assemble on a clean, flat, smooth surface such as a rug or carpet to avoid parts from being scratched.
• Remove all wrapping materials, including staples and packing straps before you start to assemble
• Do not use this product unless all bolts and screws are firmly secured and tightened.
• If parts are missing, broken, damaged or worn stop using the product until all repairs are made.
Hard
• No pre-drill holes or markings are provided on our table or desk tops.
• Please check you have all hardware before assembling.
required hardware part and quantity.
• Please retain your receipt as proof of purchase to validate your warranty.
• Keep all hardware parts out of reach of children.
• Heavy product. Do not attempt to lift or move without help
• Do not tighten screws and bolts until completely assembled.
• Failure to follow these warnings could result in serious injury.
NOTE
CAUTION
WARNING