Attop X-PACK 20 User Manual

X-PACK 20 User Manual
(Suitable for wide indoor environments operation)
Suitable for 14 years old and above
www.attoptoys.com
Customer Service Email : attop@afterservice.vip
2. Package Contents
Drone Remote
USB cable
Propeller guards
3. Charging
3
3 1
5V
Low battery warning
When the drone is flying, the indicator lights on the drone are flashing, and the remote
control handle emits a "beep" alarm sound, indicating that the drone power is too low.
At this time, the drone needs to return and charge.
Charging Guide for battery
1. Connect the USB cable with power supply, the USB LED solid Green, indicate the
USB cable is powered on.
2. Connect the battery with USB cable. When USB LED solid Red indicate charging
status. USB LED solid Green, when charging was completed.
Note： Use a power supply with standard output voltage of 5V and current greater
than or equal to 2A, otherwise there is a risk of overloading the USB cable and Battery.
The flight time is about 8-9 minutes and the charging time is about 90 minutes.
Phone clamp Battery
Spare propellers
Screwdriver
2
1
2
2
4
1. Aircraft Parameters
Propeller dia.:
Charging time:
Working temperature:
Remoter controller:
Remote Controller Parameters
Effective Control Range:
Wifi Transmission Range :
(in a wide open area with no electromagnetic interference)
Working frequency:
4. Installation
(1) Open Up all 4 blades for the drone.
This aircraft is folding structure, please do open up all four blades before power on.
(2) Install propeller guards.
Expand the buckle of the propeller guard, and install it onto the drone wings.
(3) Install battery.
Insert the battery into specified
1
position.
Keep press the buckle of battery
2
then pull the battery back to take it out.
42mm
Aircraft: 99X45X30mm
Total weight: 35g±2g
Battery: 3.7V300mAh
About 45 mins
Flight time: 6 mins
Gyroscope: built-in
-10°C to 40°C
2.4G
Motor: 6x15 4pcs
40 meters
30-40 meters
2.4G
Battery: 2xAAA
1
Remote Controller:
Keep pressing the buckle of battery
case then pull the case to take it out,
insert 2xAAA battery into specified
position.
3