The Wilson Group V12 Instructions

DISCLAIMER
No liability is assumed, directly or indirectly,
for any damage or loss resulting from the
use of The Wilson™. The manufacturer
assumes no responsibility for data loss,
improper use, damage, repairs, defects,
battery use or replacement, or any other
costs. Repair or replacement, as provided
under the Limited Warranty, shall be
the exclusive remedy of the consumer.
Talk to the Wilson shall not be liable for
incidental or consequential damages
resulting from the use of The Wilson™
or arising out of any breach of any express
or implied warranty with respect to
The Wilson™.
LIMITED WARRANTY
Talk to the Wilson grants a limited
warranty for The Wilson™ for 1 year from
the date of purchase. Please retain the
sales receipt, as proof of purchase is
required. During the warranty period,
The Wilson™ is eligible for repair or
replacement in the event of defects in
materials or workmanship. In such cases,
the defective product will be repaired or
replaced as determined by Talk To The
Wilson in its sole discretion.
Notwithstanding the preceding, this limited
warranty does not cover damage caused
by accident, improper use or unauthorized
modifications. In addition, this limited
warranty does not cover expendable
materials and defects which constitute
normal wear and tear. Please contact
Talk to the Wilson, via our website for
limited warranty questions or service.
Please note: Retailer is not responsible
for warranty claims.
Talk To the Wilson, LLC.
10105 E. Via Linda #103-196
Scottsdale, AZ 85258
USA
www.talktothewilson.com
Made in China
INSTRUCTIONS FOR USING
THE WILSON™ Recorder V12
Congratulations on purchasing
The Wilson™, a state-of-the-art digital
voice recorder.
The following are instructions for its use:
Dual type battery: Li-ion Rechargeable
battery The Wilson™ V12 comes with a
built-in Li-ion rechargeable battery.
Before using the device, you must fully
charge the battery.
Charging The Wilson™ recorder V12:
Connect the USB cable (included) the type
C plug end into the The Wilson™ recorder
(the port is located on the top) and the
other end into your computer or the
USB adapter.
The red LED stays ON continuously to
indicate that the charging is in progress.
Once the battery is fully charged, the LED
will switch to Off. You can charge the
battery when the unit is off or in use.
Optional Alkaline battery: If you want to
use Alkaline battery it requires two (2) AAA
batteries (not included). To insert batteries,
open the battery cover from the back of
The Wilson™ and remove the
rechargeable battery then insert the alkaline
batteries with negative (-) end against the
springs. Replace the battery cover.
NOTE: The rechargeable battery will be
extremely difficult to reinstall once
removed. If rechargeable cable is damaged
while removing or reinstalling it will
not be covered under warranty
Once the batteries have been inserted and
turn ON the power slide switch,
The Wilson™ will beep twice and LED
blinking once to indicate it is operational.
Note: When batteries are removed and
replaced, The Wilson™ will retain all
existing messages.
When using Alkaline batteries, they must
be a high-quality battery for this recorder.
VERSION
12
USB on Top of Recorder
TM