Philips EVNIA 27M2N5500P User Manual page 11

Note
Game mode: This model is equipped with
new features in OSD which gives you
high-quality visual experience.
• Stark Shadow Boost
This feature enhances dark scenes
without overexposing lightened
areas. The Stark Shadowboost feature
has three selectable levels that offer
texturized images with better color
saturation with higher contrast so
you can see better in both light and
dark environments. In addition, this
feature helps you fine-tune your sight
so that enemies get exposed more
quickly when gaming.
• MBR: To reduce motion blur, LED
backlight will strobe synchronously
with screen refresh, which may
cause noticeable brightness change.
• 75Hz refresh rate or higher is re-
quired for MBR.
• MBR cannot be enabled simultane-
ously.
• MBR is to adjust brightness for blur
reduction, so cannot adjust bright-
ness while MBR is turned on.
• MBR is gaming-optimized mode.
Turn on MBR may cause noticeable
screen flickering. It is recommended
to turn off when you are not using
the gaming function.
3
Resolution notification
This monitor is designed for optimal
performance at its native resolution:2560
x 1440.
When the monitor is powered on at a
different resolution, an alert is displayed
on the screen as follows: Use 2560 x 1440
for best results.
Display of the native resolution alert can
be switched off from Setup in the OSD
(On Screen Display) menu.
4
OverClock Your Monitor
The OverClock function increases the
native refresh rate, however, it does have
some associated risks along with it. Please
follow the instructions below to activate
the OverClock feature on your monitor:
1. First, check your PC's graphics card
and make sure it is capable of
achieving the maximum resolution
and refresh rate of this monitor.
2. If needed, install the latest version of
graphics card driver.
3. Ensure the OverClock signal port is
available (Please refer to the chapter
Resolution & Preset Modes in the
dedicated user manual).
4. Modify the refresh rate in the On
Screen Display (OSD) settings.
To enable the OverClock feature, you will
need to go to OSD menu > Game Settings
> OverClock.
SmartImage Game Mode Input
Smart MBR
Overclock On
Crosshair
Overclock Off
StarkShadowBoost
Smart Sniper
Low Input Lag
SmartResponse
Overclock
Resolution Refresh Rate
2560X1440 60Hz
Note
Please note that the default setting
for OverClock is off as it can cause
irreversible damage to your monitor.
If the screen is displayed abnormally
after rebooting, please switch off
the OverClock setting located in the
monitor's OSD menu. Alternatively, you
can unplug the power cable. Then, press
and hold the left button of the menu
toggle on the monitor while plugging
the power cable back in. Keep holding
the button until the screen turns on.
9

Audio Language System Setup
Input Source Adaptive Sync SmartImage
On Standard
DP
Close
Select
OK
Close