Remote controlled rotating digital outdoor antenna (10 pages)
Summary of Contents for SimTech SMDGT-5C
Page 1
Remote Controlled Rotating Digital Outdoor Antenna – SMDGT-5C User Manual [Revision 2.0 December 2019] READ THIS MANUAL CAREFULLY BEFORE USE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • KEEP THIS MANUAL FOR FUTURE REFERENCE. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
Remote Controlled Rotating Digital Outdoor Antenna – SMDGT-5C Safety Safety messages are designed to alert you to possible dangers or hazards that could cause death, injury or equipment or property damage if not understood or followed. Safety messages have the following symbols:...
Page 3
Remote Controlled Rotating Digital Outdoor Antenna – SMDGT-5C General Electrical Safety General Electrical Safety General Service Information • Inspect electrical equipment, extension • Electrically grounded equipment must have • The equipment must be serviced or cords, power bars, and electrical fittings for...
Remote Controlled Rotating Digital Outdoor Antenna – SMDGT-5C Safety Symbols The product may have safety warning labels attached to it, explained below. Understand the symbols on your product and their meanings. If any stickers become unreadable, unattached etc., replace them.
Page 5
Remote Controlled Rotating Digital Outdoor Antenna – SMDGT-5C Carbon-Monoxide Hazard Pull Hazard Slope / Fall Injury Hazard "Slam Dunk" Warning Do not use the product in Be aware that the product Be aware that using the product Do NOT attempt "slam dunk"...
Remote Controlled Rotating Digital Outdoor Antenna – SMDGT-5C Installation WARNING! Installing antennas on windy days can be dangerous. Because of the antenna surface, even slight winds create strong forces. Be prepared to safely handle these forces at unexpected moments. Do not attempt to assemble, move or mount the antenna on windy days or serious, even fatal accidents may occur.
Remote Controlled Rotating Digital Outdoor Antenna – SMDGT-5C Installation Diagram Unfold the VHF part. Take out the VHF and UHF parts. Unfold the UHF part. Screws should be on the Connect the main tubes with underside of the main tube.
Page 9
Remote Controlled Rotating Digital Outdoor Antenna – SMDGT-5C Set the main tube on the Remove the M3x14 screws square rotator box with 2pcs. from the UHF and VHF of M4x25 screws and 2pcs. of parts. M4 plastic wing nuts. Secure the screws through Connect the AL strips to the the AL strips.
Need help?
Do you have a question about the SMDGT-5C and is the answer not in the manual?
Questions and answers