ujk technology 111813 Manual

G U I D E F O R ...
DOVETAIL JIG
FINE PITCH COMB
INTRODUCTION
A fine comb kit for cutting 6mm half blind dovetails or box
joints. For use with the UJK Universal Dovetail Jig, the comb is
ideal for making small boxes and drawers.
Supplied complete with a CNC machined anodised comb,
US style guide bush, set gauge, side stops, two premium
Axcaliber cutters.
CONTENTS
Introduction
Centring Guide Bush To The Cutter
Half Blind Joint
Box / Finger joint
PARTS FOR DOVETAIL
JIG FINE PITCH COMB
2 x side stops
7.8mm Guide
Bush, without
Securing
Fine Set
Ring
Gauge
Comb (C)
WARNING! KEEP TOOLS AND EQUIPMENT
OUT OF REACH OF YOUNG CHILDREN
KEEP WORK AREA AS UNCLUTTERED AS IS PRACTICAL
Code: 111813
Page
1
1
2
3
FIG 1
2 x cutters
CENTRING GUIDE BUSH
TO THE CUTTER
To obtain the best fitting joints, it is best practice to centre the
cutter to the guide bush.
Follow steps below...
1. Insert the dovetail
cutter only a third of
the shank length into
the collet then tighten
lightly. FIG 2
2. Loosen all guide bush
adaptor screws and
plastic base screws
if fitted to the plastic
base and not a metal
router base. FIG 3
3. Fit the 7.8mm guide
bush to the guide
bush adaptor but not
the base. FIG 4
4. With the router
upside down, plunge
the router fully to
allow the cutter
to fully protrude
through the base of
FIG 5
the router.
5. Slide the 7.8mm
guide bush with
adaptor over the
cutter, taking care
not to damage the
FIG 6
cutting edge.
6. With the cutter now
protruding through
the guide bush,
tighten all base and
guide bush adaptor
screws, this will help
centralise cutter to
guide bush. FIG 7
IMPORTANT
Once the centring is complete, insert the cutter into
the collet up to the K line or ¾ lenghth of the shank
NB: It is highly recommended to test cut on practice
boards cut to the same dimensions
FIG 2
FIG 3
FIG 4
FIG 5
FIG 6
FIG 7
Continued overleaf...