Advertisement
Advertisement
Table of Contents
Related Manuals for Condura CPR51MN CG
Summary of Contents for Condura CPR51MN CG
- Page 1 PERSONAL REFRIGERATOR CPR51MN CG, CPR90TD Blk, CPR90TD Wht, CPR90TD CG...
-
Page 2: Table Of Contents
Table of contents Food Storage Parts Defrosting Handling and and Cleaning Installation Safety Getting Started Instructions Basic Temperature Control Troubleshooting... - Page 3 PARTS CPR51MN CG CPR90TD Blk, CPR90TD Wht, CPR90TD CG Actual design and location of accessories may vary depending on model. Speci cations and features are subject to change without prior notice.
-
Page 4: Handling And Installation
HANDLING & INSTALLATION When moving the ref, hold the base and lift carefully at an angle not more than 45 degrees. Do not place the ref horizontally or upside down. For proper ventilation, leave at least 12 CEILING CEILING inches of space between ref and ceiling or overhead pit;... -
Page 5: Getting Started
“MAX” or coldest setting and allow to cool for 3 hours before loading food and beverage items. For CPR51MN CG. Turn the temperature control knob to “6” or coldest setting and allow to cool for 3 hours before loading food and beverage items. -
Page 6: Temperature Control
TEMPERATURE CONTROL To adjust to desired temperature, turn the control knob clockwise or counter-clockwise. The "MAX" or "6" setting denotes the coldest temperature while the "MIN" or "1" setting denotes the warmest. Adjust the temperature according to refrigerator load. For normal load, set the control knob at “3-4”... - Page 7 Recommended Temperature Setting MIN Setting MID Setting MAX Setting Set the control knob to Set the control knob to Set the control knob to MIN when storing MED when storing MAX when storing MINIMUM amount of MODERATE amount of LARGE amount of food and beverage food and beverage food and beverage...
- Page 8 Setting No. 1 to 2 Setting No. 3 to 4 Setting No. 5 to 6 Set the control knob to Set the control knob to Set the control knob to no. 1 to 2 when storing no. 3 to 4 when storing no 5 to 6 when storing MINIMUM amount of MODERATE amount of...
-
Page 9: Food Storage
FOOD STORAGE Cool down food to room temperature before putting it inside the ref. Place food in airtight containers/ plastic. -
Page 10: Defrosting And Cleaning
DEFROSTING & CLEANING When frost in freezer is already one-fourth inch(1/4”) thick or more, it is time to DEFROST: 1. Turn OFF the temperature control knob then unplug the ref. 2. Remove all contents and detachable accessories. 3. After all the ice has melted, clean your ref with lukewarm water and mild soap. -
Page 11: Safety Instructions
SAFETY INSTRUCTIONS A. POWER CORD • Refrain from using an extension cord, octopus connection to prevent circuit overloading. • The power cable tension must be a little loose when plugged. • Keep the power cable away from the compressor. • Do not attempt to replace or repair damaged power cord. Call customer hotline or any authorized service center immediately. -
Page 12: Basic Troubleshooting
BASIC TROUBLESHOOTING PROBLEM POSSIBLE CAUSE 1. When refrigerator would not turn ON: 1. The power cord is not properly plugged. 2. The temperature control knob is in “OFF” position. 2. When refrigerator is not cooling: 1. The temperature control knob is not set according to refrigerator load. - Page 14 Fill-up this warranty card completely and mail within 15 days from date of purchase. This will activate your warranty from Condura! PRODUCT WARRANTY CERTIFICATE IMPORTANT: PLEASE READ CAREFULLY defective material and workmanship, and agrees to repair, or at its discretion, replace any defective material manufacturer’s defect and in accordance with the terms of this warranty, subject to the following conditions:...
- Page 15 CONCEPCION DURABLES INCORPORATED www.facebook.com/ConduraPhilippines www.condura.com...
- Page 16 www.condura.com...
Need help?
Do you have a question about the CPR51MN CG and is the answer not in the manual?
Questions and answers