SERVICE MANUAL
®
wk2000
hd
code 270280
Index
2
Opening Instructions & Keyboard Disassembling.
3
Internal Assembly.
4
Block Diagram.
5
Power Amplifier & Supply Board, HD Interface Board, Midi & Controls I/O Board.
6
Keyboard Contacts Board, Controls Panel Board, Trackball Board.
7
Cpu & Sound Generator Board (part 1/2).
8
Cpu & Sound Generator Board (part 2/2), Vocal Processor Interface.
9
Test Procedure, Spare Part List.
Notice
✔
Service must be carried out by qualified personnel only. Any tampering carried out by unqualified personnel during the guarantee period
will forfeit the right to guarantee.
✔
For a correct operation of the instrument, after having switched off, be careful to wait at least 3 seconds before switching on again.
✔
To improve the device's specifications, the schematic diagrams may be subject to change without prior notice.
All components marked by this symbol have special safety characteristics, when replacing any of these components use only
manufacturer's specified parts.
✔
The (µ) micro symbol of capacitance value is substituted by U.
✔
Ω
The (
) omega symbol of resistance value is substituted by E.
✔
The electrolytic capacitors are 25Vdc rated voltage unless otherwise specified.
✔
All resistors are 1/8W unless otherwise specified.
✔
All switches shown in the "OFF" position. All DC voltages measured to ground with a voltmeter 20KOhm/V.
✔
Soldering point.
Supply voltage.
✔
Male connector.
Test point.
✔
Female connector.
Flag joined with one or more flags
✔
M/F faston connector.
with the same signal name inscribed.
ATTENTION
Observe precautions when handling electrostatic sensitive devices.
✒
GENERALMUSIC S.p.A. Sales Division: 47842 S.Giovanni in Marignano (RN) ITALY - Via delle Rose, 12
¤
Phone +39(0)541/959511 - Fax +39(0)541/957404 - Internet: www.generalmusic.com
Logic supply ground.
Analog supply ground.
Chassis ground.
Earth ground.
1 1 1 1 1
Need help?
Do you have a question about the wk2000 hd and is the answer not in the manual?
Questions and answers