Princeton Tec CHARGE X IR Max Operating And Maintenance Instructions

CHARGE X
MPLS HELMET LIGHT
Operating and Maintenance Instructions
English
Battery Installation
See Figure 1
(1) CR123 Lithium Battery or (1) AA Lithium or (1) AA Alkiline.
Lithium preferred for better performance
To install battery, grip the light in either hand with the battery door
g straight
facin up. Slide battery door latch forward with your thumb
and use your free hand to open the battery door. With a battery
installed, spring tension will make this operation possible with one
hand. To close the battery door, push it closed and then slide the
latch toward you to lock.
Princeton Tec cares about the environment and recommends recycling
batteries. For more information about battery recycling, please go to:
https://www.epa.gov/recycle/used-household-batteries
WARNING !
• Always remove drained batteries immediately.
• Remove batteries during long periods of storage.
Switch Operation
See Figure 2
Charge X IR Max ships with red light selected first.
Press 1x:
Press 2x:
Press 3x:
Press & Hold from IR:
Next Press:
Next Press:
After 1s in any mode: Press 1x: Off
Press & Hold 5s:
Lock indicated by 3 flashes from red LED. While locked, any press
yields one red blink
IR Max
®
IR Low 50%
IR High
Off
Red
White
Off
Lock / unlock
Troubleshooting
If the Charge X IR Max fails to light:
• Check the battery for proper installation.
• Replace battery if proper installation is confirmed.
USA– International 1-Year Warranty
WARRANTY – Princeton Tec warrants this product to be free from
defects in workmanship and materials under normal use for one year.
This warranty covers all of the component parts of the product except
batteries. This warranty does not cover deterioration due to normal
wear or damage due to misuse, alteration, negligence, accidents, or
unauthorized repair. Princeton Tec will repair or replace parts which are
defective in workmanship or materials. Your authorized Princeton Tec
Dealer and Princeton Tec are the only facilities authorized to repair the
product. After (3) unsuccessful attempts (within the warranty
period) to repair the product, you have the right to elect replacement
of the product or a refund of the purchase price less allowance for use
of the product. NO INCIDENTAL OR CONSEQUENTIAL DAMAGES
ARE INCLUDED IN THIS WARRANTY. (Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you.) This warranty
gives you specific legal rights, and you may also have other rights which
vary from state to state.
Princeton Tec reserves the right to change product specifications
without notice.
FOR CALIFORNIA RESIDENTS
WARNING: This product contains Bisphenol A (BpA) a chemical
known to the State of California to cause birth defects or other
reproductive harm.
Return Policy
If your light fails to operate, follow these simple steps:
1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement, first contact
Princeton Tec customer service on
1-800-257-9080 to request an RMA number. Please have your
light model, date of purchase and a brief description of the fault
your are experiencing. No warranty repairs will be accepted
without an RMA number.
3. Return the light to: Princeton Tec, PO Box 8057 Trenton NJ
08650. Postage due and freight collect items will not be accepted.
4. Upon receipt your light will be processed in about two weeks.
Please allow additional time for return transportation from NJ.
Princeton Tec
PO Box 8057, Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2025 Princeton Tec