Advertisement
Advertisement
Table of Contents
Summary of Contents for Resfab GM-3PN
- Page 1 GM HEATED DISPLAY CASES Installation and Operation Manual MODEL GM-3PN, GM-4PN, GM-5PN Available in 208V or 240V Single Phase for all models Manufactured by Resfab Equipment Inc. 1-866-359-0808 WWW.RESFAB.COM WARNING Do not operate this equipment before reading this manual...
- Page 2 In no event shall Resfab be liable for the loss of use, loss of revenue, loss of product, loss of profit or for indirect, incidental, special or non-sequential damages including.
- Page 3 INDEMNITY: Buyer agrees to indemnify, hold harmless and defend Resfab from and against any and all liabilities and expenses arising out of any injury or damage with results from Buyer’s use, misuse, negligence, misapplication, modification, ownership, failure to inspect, maintain or repair the Products or Buyer’s violation or alleged violation of any federal, state, county or local laws or regulation, including without limitation, the laws and regulations governing product safety and labor practices.
-
Page 4: Food Safety
WARNING Read this safety information before operating this equipment. The safety instructions need to be followed to avoid serious injury and to avoid damage to equipment or property. • The equipment wiring and electric installation must be done by a qualified electrician. •... - Page 5 10 FEET OF SERVICE WIRE, PLUG & RECEPTACLE HEATED DISPLAY CASE ELECTRIC SPECIFICATION AMP. AMP. SERVICE WIRE MODEL DESCRIPTI VOLT WATT 120/208 120/240 GM-3PN Hot Case, 3 120 / 208 or 240 1641 10.5 GM-4PN Hot Case, 4 120 / 208 or 240 2116 13.4 12.6...
-
Page 6: Control Panel
CONTROL PANEL Heater Switch LED Light Switch 2x Digital Controller OPERATION START-UP WARNING DO NOT OPEN THE ELECTRICAL COMPARTMENT WHEN POWER IS ON AND UNIT IS IN OPERATION MORNING START-UP • Turn the LED Light and Heater Switches the the ON position. •... -
Page 7: Temperature Adjustment
TEMPERATURE ADJUSTMENT After placing the food into the hot case, it may be necessary to adjust the temperature settings in order to maintain the proper internal temperature for the food in each pan. Use an approved food thermometer to read the internal temperature of food on each pan. The temperature settings in the Hot Case should be adjusted lower or higher to maintain the food temperature. - Page 8 Cleaning the Hot Case WARNING • Always turn the power switch OFF before cleaning the hot case. • DO NOT put water into the wells or ceramic heaters • Inner surfaces and heater components can become extremely hot and cause injury if contacted. Allow enough time for all surfaces to cool before cleaning the wells.
- Page 9 Cleaning Steps at End of Day STEP 1 Turn the power switch on OFF position, slide open doors and allow plenty of time to cool down the hot case. STEP 2 Remove the sliding glass doors. To do this, gently lift each glass door from the bottom rail guide using two hands, and then rotate the lower edge toward you.
- Page 10 HEATING PARTS ITEM QTY PER MODEL PART # DESCRIPTION WATT 54701 PAN HEATER 54201 CERAMIC HEATER GM Operations Manual Jan 2025...
- Page 11 GLASS QTY PER MODEL ITEM # PART # DESCRIPTION 30303 FRONT CURVE GLASS 3P ASSY 30403 FRONT CURVE GLASS 4P ASSY 30503 FRONT CURVE GLASS 5P ASSY 30202 SIDE GLASS 18302L LEFT HAND SIDING DOOR 3P ASSY 18302R RIGHT HAND SIDING DOOR 3P ASSY 18402L LEFT HAND SIDING DOOR 4P ASSY 18402R RIGHT HAND SIDING DOOR 4P ASSY 18502L LEFT HAND SIDING DOOR 5P ASSY...
-
Page 12: Electric Parts
ELECTRIC PARTS QTY PER MODEL ITEM # PART # DESCRIPTION 54352 LED 12'' 54351 LED 24'' 54354 2'' jumper wire 54355 79'' LED wire 59434 24V transfo 59484 YELLOW SWITCH 59483 RED SWITCH TEMPERATURE 59952 CONTROLER 54356 LED HUB 24V GM Operations Manual Jan 2025...
Need help?
Do you have a question about the GM-3PN and is the answer not in the manual?
Questions and answers