Download Print this page

Kettal A KSA000300 Assembly Instructions Manual

Meeting table

Download this manual

Meeting Table,

Assembly instructions

Need help?

Do you have a question about the A KSA000300 and is the answer not in the manual?

Page 1 Meeting Table, Assembly instructions...
Page 2 A Meeting Table User Manual Overview Screws 1. Table top 2. Beam 3. Trestles (x2) 4. Beam end (x2) 5. Cable holder 6. Screws DIN 7991 M6x16 (x18) 7. Screws DIN 7984 M6x60 (x4) 8. Allen key H3 (For studs, already assembled, just need to tighten) 9.
Page 3: Before Assembly
Kettal Before assembly Place all the pieces above a rug to avoid broken corners Unscrew the beam from the table top...
Page 4 A Meeting Table User Manual Steps Place both trestles and the beam above a rug and remove the beam end Before placing the trestles, make sure the T-shaped bars are oriented to fit into the beam recess. Insert beam on both trestles...
Page 5 Kettal Don't screw the T-shaped bars. Wait until the revelant step * Repeat the process is required. in the other trestle. Place the table top and fit the plate into the recess. Anchor 4 side screws + 2 central screws...
Page 6 A Meeting Table User Manual Screw the T-shaped bars to the beam...
Page 7 Kettal Select the power input connector that suits better the installation Do not remove the protective cover from the power input that is not in use. INPUT INPUT LEFT RIGHT...
Page 8 A Meeting Table User Manual Fasten the cable with the cable holder and plug it into the nearest power outlet Level the table...
Page 9 Kettal. Aragón 316. 08009 Barcelona. Spain...