Advertisement
Table of Contents
Advertisement
Table of Contents
Summary of Contents for Knightsbridge OS021
- Page 1 INSTALLATION & MAINTENANCE MANUAL OS021...
-
Page 2: General Instructions
These instructions should be read carefully and retained after installation by the end user for future reference and maintenance. These instructions should be used to aid installation of the following product: OS021 SAFETY • This product must be installed in accordance with the latest edition of the IEE Wiring Regulations (BS7671) and current Building Regulations. - Page 3 m hole on the side of the fitting to be used (see Fig. 1) *(T8BLED26 batten shown) Fig. 1 • Remove the nut from the sensor housing • Insert the sensor, refit the nut and tighten • The sensor is pre-wired with approximately 0.5m single core cables. Ensuring correct polarity is observed, carefully wire as follows: Live In (brown), Neutral In (blue), Neutral Out (white), Live Out (black) (see Fig.
- Page 4 • To change the DIP switch settings, unscrew the top cap of the sensor by turning anti-clockwise • After changing the DIP switch settings, replace the cap ensuring that a tight seal is achieved • Switch on and check for correct operation DIP SWITCH LAYOUT...
-
Page 5: Dip Switch Settings
DIP SWITCH SETTINGS This is the time period the lamp remains on after no motion is detected When set to Disable, the daylight sensor will switch the lamp on when motion is detected regardless of the ambient light level... -
Page 6: Warranty
WARNING This product must be disconnected from the circuit if subjected to any high voltage or insulation resistance testing. Irreparable damage will occur if this instruction is not followed. GENERAL This product should be recycled in the correct manner when it reaches the end of its life. Check local authorities for where facilities exist. - Page 7 Manufacturers Declaration of Conformity For ML Accessories (Knightsbridge) Electrical products in accordance with CE marking ML Accessories Ltd. Declare that all products have been designed, manufactured, and tested in accordance with the requirements of the relevant legislation CE marking legislation...
- Page 8 Manufacturers Declaration of Conformity For ML Accessories (Knightsbridge) Electrical products in accordance with UKCA marking ML Accessories Ltd. declare that all products have been designed, manufactured, and tested in accordance with the requirements of the relevant legislation UKCA marking legislation UK SI 2016 No.
- Page 9 Supplied By: (UK) Manufacturer ML Accessories Ltd, Unit E Chiltern Park, Boscombe Road, Dunstable LU5 4LT, www.mlaccessories.co.uk (EU) Authorised Representative nnuks Holding GmbH, Niederkasseler Lohweg 18, 40547 Düsseldorf, Germany, Email: eprel@nnuks.com ML Accessories Limited LU5 4LT www.mlaccessories.co.uk AVJUL22_V2...
Need help?
Do you have a question about the OS021 and is the answer not in the manual?
Questions and answers