Page 2
SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual Congratulations!!! You have purchased one of the best, integrated Radio/TV amplification systems available for in-vehicle use today. * Integrates TV and Radio sound into a single system for simplicity, enhanced performance and ease of use.
Page 3
SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual Front Panel Controls: * Radio Gain adjustment * TV Gain adjustment * 3D Field adjustment * Radio Mode LED indicator * TV Mode LED indicator * 100Hz adjustment * 1KHz adjustment...
Page 4
SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual Provides a Three-Dimensional Image from a Standard Stereo Source! Benefits: Natural 3D sound image from any two speaker stereo system Based on characteristics of the human hearing system for natural, non...
SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual Front/Rear Panel Description (1) Front panel view Radio 3-BAND EQUALIZER 3D-Field Gain Gain Radio 100Hz 1kHz 10kHz Front panel description: 1. Radio gain control---Adjust gain to match Radio signal level.
Page 8
Do not connect any cable to the TV In ,Hi Level Jack if this input is used . 4.Line in ,Radio--Connect to variable line output from radio (if available). Do not connect the 8 pin harness to the SRS1000 if this input is used. 5.Main Connection Input. Use included 16 pin wire harness to apply power, TV mode trigger, and all speaker outputs though this connection.
SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual System Connections (2) Car Radio/Tape Note: Be sure that left & right speaker channels are connected properly from TV, Radio, and to speakers. Care should Note: be taken to ensure proper polarity (+ to + Connect Low Level input or and - to -).
First Time Operation Important: Before Applying Power: a) Set all controls on SRS1000 to mid position (slot in knob will be vertical). b) Be sure TV mode trigger is not active (ie: 0 VDC) c) Be sure that TV and Radio are off System Set-Up (Gain Matching, EQ setting, 3D Effect setting) 1) Apply power to SRS1000.
Page 11
SRS1000 Theater Sound Owner's Manual SRS1000 Theater Sound Owner's Manual 7) Adjust EQ until desired sound quality is reached. This is done by turning each of the 3 knobs under "3 Band Equalizer" on the front panel. 100Hz is for Bass, 1 Khz is for midrange, and 10 Khz is for Treble.