Ear protection must also be worn to prevent a possible hearing loss. Use clean dry regulated compressed air at the recommended pressure. Use only fasteners made or recommended by Airco Fasteners Never exceed the maximum recommended operating pressure of this tool.
Page 3
Press the latch mechanism and open the magazine unit. Load the fasteners into the magazine. Close the magazine. (for queries contact your local Airco Fasteners branch on 1300 139 057). 3.2 General operating instructions 3.2.1 Types of actuating and triggering systems. For tools without a contact safety,...
- to reduce unnecessary wear to the tool Any defective or improperly functioning tool must be immediately be disconnected from the compressed air supply and returned to Airco Fasteners for inspection / service. 3.3 Precautionary measures ’Respect your tool and never engage in horseplay’...
Page 5
Remove faulty nails NO FASTENER Nails with unusualy supplied by and load nails DRIVEN large head Airco Fasteners are supplied by Wrong angle nails loaded Airco Fasteners manufactured to correct specifications. Check range of tool Remove nails and use...
Page 6
FAILURE POSSIBLE CAUSES CHECK METHOD SOLUTION NAILS DRIVEN DO Defective Piston NOT FULLY Return to Airco Ring (worn or PENETRATE THE Fasteners for service broken) WORK PIECE. Remove nails and use Incorrect nails are diameter within loaded. working range of the tool.
Page 9
SPARE PARTS LIST FOR AIRCO A100 COIL NAILER...
Need help?
Do you have a question about the A100 and is the answer not in the manual?
Questions and answers