Mizu 4205576 Installation Instructions

Drift Twin Rail Shower 250mm ABS Overhead
Prior To Installation
The Mizu Drift Twin Rail Shower must be installed to the requirements of AS/NZS 3500.1 by
a qualified plumber. It comes to you already factory assembled and tested. We do not
recommend the dismantling of any internal part of the product. The Mizu Drift Twin Shower
is tested and sealed so as to give the best performance.
Where water pressure exceeds 500Kpa a pressure limiting device must be fitted as per
requirement in AS/NZS 3500.1
This shower may not be suitable for use with gravity-fed water heaters, low and unequal
pressure supply networks, instantaneous water heaters, tempering valves and thermostatic
mixing valves.
Note: Please consider height of water inlet point at rough in stage. Recommended height is
1800mm from finished floor. Although consider end user requirement.
Mizu - Drift Twin Rail Shower 250mm ABS Overhead with Top Rail Water Inlet (6 Star)
with Top Rail Water Inlet (6 Star)
Page 01 of 04