Advertisement
Quick Links
1.DESCRIPTION:BED RACK SYSTEM-UTV
2.APPLICATION: Can Am Defender UTV
3.PARTNUMBER:YK--UTV-LMJ
4.KITCONTENTS:
ITEM.
QTY
2
4
2
2
2
2
2
1
2
2
80
88
4
Topper Rack
DESCRIPTION
LMJ-1 LMJ-2
LMJ-3
LMJ-4
LMJ-1B
LMJ-5
LMJ-6
LMJ-WK
LMJ-WK-ZJ-B
LMJ-WK-ZJ-C
M8×20/Flange Bolt M8×20
M8/Lock Nut M8
M6/Hand Knob M6
Advertisement
Summary of Contents for Hornet YK-UTV-LMJ
- Page 1 Topper Rack 1.DESCRIPTION:BED RACK SYSTEM-UTV 2.APPLICATION: Can Am Defender UTV 3.PARTNUMBER:YK--UTV-LMJ 4.KITCONTENTS: ITEM. DESCRIPTION LMJ-1 LMJ-2 LMJ-3 LMJ-4 LMJ-1B LMJ-5 LMJ-6 LMJ-WK LMJ-WK-ZJ-B LMJ-WK-ZJ-C M8×20/Flange Bolt M8×20 M8/Lock Nut M8 M6/Hand Knob M6...
- Page 2 ITEM PICTURE 2 LMJ-2 3 LMJ-3 LMJ-1 4 LMJ-4 5 LMJ-1B 6 LMJ-5 7 LMJ-6 8 LMJ-WK 9 LMJ-WK-ZJ-B 10 LMJ-WK-ZJ-C 1 1 Flange Bolt M8 × 20 1 2 Lock Nut M 8 1 3 Hand Knob M6 14 Instruction Manual...
- Page 3 INSTALLATION INSTRUCTIONS-BED RACK SYSTEM-Can Am Defender Item Description Quanti- LMJ-1 LMJ-2 LMJ-3 LMJ-4 LMJ-1B LMJ-5 LMJ-6 LMJ-WK LMJ-WK-ZJ-B LMJ-WK-ZJ-C M8×20/Flange Bolt M8×20 M8/Lock Nut M8 M6/Hand Knob M6...
- Page 4 1. Arrange LMJ-1, LMJ-1B, LMJ-2, LMJ-3, and LMJ-5 as shown in figure below. Fully tighten with M8 bolts and M8 Lock nuts assembling both sides and securing them together with LMJ-5 . Note: the positioning of LMJ-2, LMJ-3 will determine the height. 2.
- Page 5 Twist Lock anchors (do not fully tighten) to the bottom of each foot slot. Position them so they insert in the bed holes of your vehicle. 6. Insert Hornet Twist Lock Anchors and spin down the Knobs but do not tighten until rack and an- chors are fully seated on the bed.
- Page 6 Top Basket Assembly The top basket assembly can be attached while the rack is on your vehicle, but you may find it easi- er to lift the rack off your vehicle and set it on the floor or bench for easier access to the top of the rack.
Need help?
Do you have a question about the YK-UTV-LMJ and is the answer not in the manual?
Questions and answers