Hisense 43E7NQ User Manual page 5

„ Moving/Transportation
Before moving this TV, disconnect all cables
and move in the vertical position only. Grasp
the device on the upper and lower edges of
the frame.
- Do not press or put stress on the front
panel of the TV. It may take two or more
people to carry larger TVs.
If you have to briefly lay down the TV, place
the unit with its entire front surface lying flat
on soft material.
The LED screen is made of glass and can
break if is not handled properly. Always wear
rubber gloves to carry the unit. If the LED
screen is damaged, liquid crystal might leak
out. In case of skin contact, immediately
rinse thoroughly with water.
„ Power Supply
Incorrect voltages can damage the TV. Only
connect this unit to a power supply with the
correct voltage and frequency noted on the
type plate, using the supplied power cable.
The power plug must be easily accessible
so that the device can be disconnected at
all time. The unit is live, even if in standby
mode, as long as the unit is connected to a
power outlet.
It is recommended that this unit is placed on
a dedicated circuit.
- Do not overload the power outlets by
connect too many appliances to the
same outlet. Overloaded wall outlets,
extension cords, etc. are dangerous and
can result in electric shock and fire.
After power off, don't turn it on again in 5
seconds. Frequent switching power supply in a
short period of time can cause abnormal TV.
„ Power plug and power cable
-
Do not touch the power plug with wet
hands.
- Do not place heavy objects on the power
cable. Route the cable so that it is not
kinked or laid over sharp edges, walked
on or exposed to chemicals. A power
cable with damaged insulation can
cause electric shock and fire.
- Pull the power plug, NOT on the cable
when disconnecting. The cable can
become damaged and cause a short
circuit if pulled on.
- Do not place the power cable near a
high temperature object.
- Do not move the TV with the power
cable plugged into a socket.
- Do not use a damaged or loose power
cable, or a damaged socket outlet.
- Do not use any power cords other than
the one supplied with this unit.
- MAIN plug on the power cord is used as
the disconnect device, the disconnect
device and socket-outlet shall be easily
accessible.
„ Set-up
Check that the location is suitable to bear
the load of the TV. Place on a level, sturdy
and horizontal base. Ensure that the unit
does not hang over the edge of the base
when placed in or on furniture. If placed on a
cart, use caution when moving to avoid the
unit from tipping over.
- Place the unit in a normal upright
horizontal position. It must never be
operated vertically, lying flat or hanging
overhead from the ceiling.
- Place the unit where it is not exposed to
direct sunlight or other sources of heat.
When mounting the TV on a wall, follow the
instructions supplied with the wall-mount,
make sure not to install the TV by hanging
the power and signal cables on the back of
the TV.
„ Air ventilation and high
temperatures
Install your TV only where there is proper
ventilation, and ensure that there is at least
10 cm free space on the sides and 20 cm
above the unit for air circulation. Excessive
heat and obstruction of ventilation could
lead to fire or early failure of some electric
components.
- Do not block any ventilation openings
with newspapers, tablecloths, curtains,
etc.
- Do not dry clothing etc. on top of the unit.
C