Advertisement
Quick Links
BEDIENUNGSANLEITUNG - OPERATING INSTRUCTIONS - NOTICE D'UTILISATION
KS TOOLS Werkzeuge-Maschinen GmbH
KS TOOLS PDA Région de Brumath
550.1690
6 + 12V Batterietester
6 + 12V Battery tester
Testeur de batterie 6-12V + alternateurs
Seligenstädter Grund 10 - 12
●
1 rue de Londres
F - 67670 Mommenheim
●
●
D - 63150 Heusenstamm
e-mail: kstools@kstools.de
●
●
e-mail: kstools@kstools.fr
●
DE/TTE/HBA/06-04-2022
www.kstools.com
●
www.kstools.fr
●
Advertisement
Related Manuals for KS Tools 550.1690
Summary of Contents for KS Tools 550.1690
- Page 1 KS TOOLS Werkzeuge-Maschinen GmbH Seligenstädter Grund 10 - 12 D - 63150 Heusenstamm e-mail: kstools@kstools.de www.kstools.com ● ● ● ● KS TOOLS PDA Région de Brumath 1 rue de Londres F - 67670 Mommenheim e-mail: kstools@kstools.fr www.kstools.fr ● ● ● ●...
- Page 2 Introduction Dear customer! Thank you for buying one of our products. You can find all the information you need in these operating instructions. Please read the instructions completely with care and observe the advice given. The operating instruction is part of the item and should be kept intact.
- Page 3 4. Operation Intended use of the lead battery tester includes: • Determination of battery status for a 6 V or 12 V motor vehicle battery to at least 36 Ah with a running measurement (with 100 A). • running voltage measurement (uncharged) on running engine •...
- Page 4 The following safety rules must be observed when working on motor vehicle or measuring battery voltage under load: A carbon dioxide fire extinguisher must be easily and permanently available. Steel wool, grease rags, solvents, gasoline, or fuels may only be stored in designated places and containers. Make sure to observe the rules for fire protection.
- Page 5 - An „no-load voltage” is displayed in the polarity connection. The battery voltage of approx. 12.4 V is required before performing a charge test. After performed charge the no-load voltage is for this one. The battery less than approx. 12.4 VDC, so is still already damaged battery. Nothing happens. If there is no display, probably one of the clamps is loose or does not have any contact.
-
Page 6: Maintenance
• Start the machine (engine) and read the voltage value during the starting process. Compare the value with the following table. If the value is substantially lower than the „cranking” voltage, either the starter is defective or there is a bad cable connection (transmission resistance) or the battery is too small (under-sized) for the motor vehicle. RUNNING VOLTAGE (IN V) 10,2 10,4... - Page 7 Also defects in tools caused by the use of accessory parts or other parts that are not KS Tools original parts. • Tools which have been modified or equipped with additions.
Need help?
Do you have a question about the 550.1690 and is the answer not in the manual?
Questions and answers