ENDEAVOUR ET4393 User Manual

ET4393 Brake Fluid Bleeder
This instruction manual describes the operation this pressure brake bleeder. The safe
operation of this equipment can only be realised if you read the operating instructions
and safety instructions completely and strictly follow the instructions contained therein.
Please use and handle this brake fluid bleeder in a professional manner that complies with safety
specifications. Only trained personnel should be permitted to use this device to change brake fluid.
For Your Safety
Work performed incorrectly can lead to injury or property damage!
DOT
Operator must have basic theoretical knowledge of automobile braking
systems.
Only applicable to bleed DOT fluid in automobile brake and clutch systems. Any
other kind of use beyond the scope shall be deemed as not being used as
required, which may cause equipment failure and must be prohibited. In case of
incorrect application, the manufacturer shall not be liable for any damage
caused. The risks arising therefrom shall only be borne by the operator.
For safety reasons, the working pressure must NOT exceed 3 bar, otherwise
brake pipelines and this tool may be damaged.
Brake fluids are toxic and can lead to serious injury!
 Avoid all contact with brake fluid.
 Wear safety goggles to minimize the risk of injury from splashing.
Wear suitable, protective gloves to minimize the risk of injury caused by

skin contact.
In case of skin contact with brake fluid, wash off immediately with water.

 Remove contaminated clothing.
Do not carry any rags or anything else that has been in contact with brake
fluid in your clothes.
Ensure the battery is healthy and the voltage is not lower than 12V.
After bleeding, the vehicle braking system performance must be road tested.
Perform self bleed on the equipment regularly.
User Manual