Subscribe to Our Youtube Channel
Related Manuals for Nomadic NA-A2 Series
Summary of Contents for Nomadic NA-A2 Series
- Page 1 Installation & Operation Guide NA-A Legless Electric Awning NA-A2-400 / NA-A2-350 / NA-A2-300 Models (12V DC) 241114 2904 Airport Parkway Elkhart, IN 46514 (480) 576-2489 | (883) 287-9500 www.NomadicAwnings.com...
-
Page 2: Table Of Contents
It is important to read this installation guide obtained this document from a before starting to ensure that the awning is source other than Nomadic Awnings installed correctly and works properly. Co., please scan the QR code below to ensure that you have the latest Due to ongoing improvements, Nomadic version available. -
Page 3: Important Safety Instructions
Do NOT add any devices or accessories Read and comprehend these instructions to the awning unless specifically before installing, using, servicing, or maintain- authorized in writing by Nomadic ing the awning. Awnings Co. Poor installation, operation, servicing, or maintenance of the awning can result in severe injury. - Page 4 If the weather goes bad (rain, snow, thunder, etc.) stop using the awning and close it immediately. Before driving, ensure the awning is properly attached, the screws are not loose, and fabric is stored properly. Legless Electric Awning Guide Nomadic Awnings Co. 241114...
-
Page 5: Itemized Parts List
• M6 hex driver, socket or bit Mounting Bolts (M6x50mm) • 5/32" hex driver, socket or bit • Silicone caulking Mounting Nuts • Spacers or adapters if roof rack is not flat or level Washers • Crescent wrench Nomadic Awnings Co. Legless Electric Awning Guide 241114... -
Page 6: Installation Steps
Verify that all parts are undamaged. If there Body are any parts that are damaged or missing, please contact Nomadic Awnings Co. Installation should be performed by at least If the roof rack surface is curved, use two people. In addition, it is recommended... - Page 7 Attach the brackets to your roof rack using the 8 mounting plates and 16 bolts, washers and nuts provided. P ate M6 nut and washer Silicone caulking M6 x 50mm bolts Nomadic Awnings Co. Legless Electric Awning Guide 241114...
-
Page 8: Electrical Case Wiring
Extend the wires as necessary to Lastly, install your switch panels in your vehicle position the switches in the most according to the manufacturer’s instructions. suitable location within your vehicle. Legless Electric Awning Guide Nomadic Awnings Co. 241114... -
Page 9: Awning Operation
4. Once adjusted, re-tighten Bolt A by turning it clockwise. Two Bolts Below Use a wrench to turn the Remove the 3 crank clockwise to manually bolts from the retract the awning. left endcap. Raise Lower Nomadic Awnings Co. Legless Electric Awning Guide 241114... -
Page 10: Awning Maintenance
Visit www.NomadicControls.com for the latest news! Nomadic Controls is bringing the latest Do not use a drive-through car wash. in remote control technology for your Nomadic Awning and Nomadic Before departure, please make sure Cooling AC units. -
Page 11: Troubleshooting
PROPER USE OF AWNING Please contact us about replacing the awning fabric or other components if that IMPORTANT NOTICES ever becomes necessary. Your Nomadic Electric Awning is intended primarily to provide shade on sunny or NOMADIC TECHNICAL SUPPORT cloudy days. •...
Need help?
Do you have a question about the NA-A2 Series and is the answer not in the manual?
Questions and answers