IW-MULTIPOOL 2 pH-Rx ENGLISH INDEX GENERAL RULES ............................. 4 SHIPPING AND TRANSPORTING THE PUMP ................. 4 INSTALLATION STANDARDS ......................4 PROPER USE OF THE PUMP ......................4 OPERATION .............................. 5 OVERALL DIMENSIONS ........................5 TECHNICAL FEATURES ........................5 INSTALLATION ........................... 6 HYDRAULIC FEATURES ........................
The servicing and maintenance of the dosing pump and all its accessories must always be carried out by qualified personnel. AQUA SpA cannot be held responsible for damage to persons or things caused by poor installation or incorrect use of the dosing pump.
IW-MULTIPOOL 2 pH-Rx ENGLISH 2. OPERATION The IW-MULTIPOOL 2 is a digital device with double peristaltic that can be controlled remotely via our INSIDE WATER software. The device can be connected to various sensors that allow the control of the chemical- physical parameters of the water in a swimming pool such as pH or oxidation-reduction power (ORP).
IW-MULTIPOOL 2 pH-Rx ENGLISH INSTALLATION To install the control unit on a wall follow the images below. To ensure maximum performance we suggest installing the unit at a maximum height from the ground of 1.5 metres. 6/15...
IW-MULTIPOOL 2 pH-Rx ENGLISH HYDRAULIC FEATURES ABSORBED HOSE FLOW RATE PRESSURE POWER MATERIAL Watt Santoprene® Santoprene® The above data refer to tests carried out with water at room temperature. Values can fluctuate by 10%. Chemicals with viscosity different than water may also have significant variations on the flow rate. CONTENT OF THE PACKAGE (Standard version) ▪...
IW-MULTIPOOL 2 pH-Rx ENGLISH 3. IW-MULTIPOOL 2 pH-Rx GENERIC PUMP CONTROLS The control panel of the IW-MULTIPOOL 2 pump is composed of a status LED for each pump (1 and 2), a multifunction button on the back that allows you to perform various actions and a LED connected to the functions of the button (3).
IW-MULTIPOOL 2 pH-Rx ENGLISH MEANING OF THE MULTI-FUNCTION BUTTON AND LED The pump is equipped with a blue button (on the back of the unit next to the antenna) which has the following functions: If it is pressed for more than 5 seconds, the multipool 2 switches to “access point” mode (flashing white LED);...
IW-MULTIPOOL 2 pH-Rx ENGLISH TROUBLESHOOTING The IW-MULTIPOOL 2 is a relatively robust device, so the chances of mechanical failure are low. Chemical leaks can sometimes occur from loose hose nipples or nuts or simply due to a broken peristaltic tube. If any of the above cases occur, the user should first disconnect the unit from the power supply, then replace the damaged part, clean the unit of any chemical leaks, replace any damaged parts and then restart the pump.
If the control unit does not turn on, check the status of the fuse and replace it if necessary (the position of the fuse is shown in the previous images). 7. WARRANTY The product is covered by the manufacturer's warranty for manufacturing defects. The methods and conditions are set forth in the "General Conditions of Sale" document of AQUA SpA. 12/15...
Page 13
IW-MULTIPOOL 2 pH-Rx ENGLISH EXPLODED VIEW IW16005_rev.0 17/04/24...
Need help?
Do you have a question about the Inside Water IW-MULTIPOOL 2 pH-Rx and is the answer not in the manual?
Questions and answers