Shelfology Popsicle Installation Manual

Popsicle
Hook Installation Guide
1
Let's go! Position the hook on wall in
desired location. Align one of the
screw holes with a wall area backed
by a stud or blocking. See Rad Tip #1
below. Use a drill to install screw
into this location. If there is no stud
or blocking, skip to step 6.
5
Install upper screw into marked
location. Check for level, and install
remaining screw into lower screw
hole. Repeat for additional hooks.
Skip to step 9.
9
Stand back and relax, you did it!
Give your cat a celebratory st
bump, if present. Gently hang your
authentic 1980s patchwork bag on
your Popsicle wall hook and enjoy!
Tools You'll Need
Drill
Measuring Tape
Level
Pencil
Innate Radness (Done!)
¼" Diameter Drill Bit*
2
Level the hook, use bullet level if
needed. Mark second hole with
pencil or screw tip.
6
For installation into drywall only,
Position hook in desired location.
Level the hook, and mark both screw
hole locations with a pencil or
screw tip.
10
Post your sweet Popsicle shel e on
Instagram. Warning: Rad prizes may
apply to shel e of the week.
@shelfology#radshel e
What's Included
1x
Popsicle Hook
2x
Wall Fasteners
2x
Wall Anchors
3
Install lower screw. You are done!
When installing multiple hooks, see
step 4 and 5, otherwise, skip to
step 9.
7
Drill a pilot hole for each marked
location with a ¼ diameter drill bit.
Install wall anchors into each hole.
Be sure the lip of the anchor sits
ush with the wall surface.
Rad Tip #1 Blocking refers to
pieces of wood or other material
that run between wall studs in
order to provide support and
attachment sites for your shelf or
hook.
Rad Tip #2 You can turn a short
level into a long one by laying it on
a straight object like a yard stick.
Just hold it against the wall with
your bullet level on top and
measure!
**WARNING: Hooks must be
correctly installed into studs or
wall blocking. Failure to do so may
result in sagging hooks, falling
objects, or serious injury.
Still need help? Speak with a
Shelfologist today or see back of
installation guide for further
motivational support.
C A L L A S H E L F O L O G I S T
949.244.1083
C H A T W I T H A S H E L F O L O G I S T
hello@shelfology.com
V I S I T U S O N L I N E
www.shelfology.com
How did we do?
You'll get an email soon asking for a
product review, and we'd be stoked if
you oblige. You rock in advance!
4
Position your next hook over a wall
area backed by a stud or blocking.
Use a level to align your hooks. See
Rad Tip #2 below. Mark the upper
hole with a screw tip or pencil. If no
solid backing is found, see steps 6
through 9.
8
Install the screws through the hook
and into the wall anchors.