MAXHUB ST33 Installation Manual

Installation Guide
·
To ensure using the stand correctly and safely, please read
this manual carefully before installation.
·
This model is recommended to be used for 55-86 inch
interactive flat panel.
·
Maximum load capacity: 100KG.
Bill of materials
A-Left frame 1pc
B- Right frame 1pc
M8 screw
M12 spring washer
M6 screw*
Phillips screwdriver (self-provided)
Adjustable wrench (self-provided)
Note: "*" indicates that due to different model, some models may contain this accessory.
Please refer to the actual situation
C- Wall mount 1pc
E- Castors 4pcs
F- Wall mount bracket 2pcs*
D- tray 1pc
14pcs
M8×25mm
4pcs
M6×130mm
2pcs
1pcs
1pc
Installation steps
Step 1
Adjust the wheel to the brake state and
screw it into the frame ( Figure 1).
When turning the wheel,
adjust the wheel to the
brake state in advance
A
B
Spring
washer
Spring
washer
E
Figure1
Step 3
Attach the other frame on the other
end of the wall mount (Figure 3).
Figure 3
Step 2
Attach the wall bracket to the end
frame (Figure 2).
Screw holes
1
2
C
3
4
5
M8×25mm
6
screw
Front
Screw hole position suggestion
Front
Monitor size Matching hole
55"
3rd and 6th holes
65"- 70"
2nd, 5th holes
75"- 86" 1st and 4th holes
Figure 2
Step 4
Assemble the tray between the two
frames (Figure4).
Insert the tray into
the positioning bolt
on the column firstly
Snap the tray into
D
the positioning bolt
Tighten all bolts
Figure 4