Table of Contents
Advertisement
ADJUSTMENTS
CYCLE LOCK PIN COLLAR
_-CYCLE LOCK
DISC EDGE
ALL
MODELS
(p
ADJ.
40B
CYCLE
LOCK
PIN:
Observing
from
the rear
of the machine,
position
the Add
- Subtract
Gate in Plus or Minus and partially rotate the Drive Shaft.
Adjust for a maximum
of .005 clearance
between
the edge of the Cycle Lock Disc and the face of the Cycle Lock Pin Collar
by turning Nut 1.
Lock the clearance
with Nut 2.
Oil the Pin.
EQUAL MESH---20
2
Steg
ACCUMULATOR DIAL GEARS /
Z
/CYCLE
LOCK DISC
2
FA.
CLEARANCE
CLEARANCE © 22%,
'CYCLE LOCK PIN
ALL
MODELS
FIG. 4
FIG 2
ADJ.
40C
DIRECTIONAL
CONTROL
SLIDE
- PLUS
AND
MINUS:
Fig. 1.
Have Nut A loose, de-
press
the Plus and the Minus
Keys
simultaneously
until the Rollers
have equal contact with the Direc-
tional
Control
Slide,
as illustrated.
Tighten
Nut A.
Observe
that the Add
- Subtract Gate
does
not
move
when tightening the Nut.
To test for equal throw
of the Directional
Control
Slide and for equal mesh
of the Add
- Subtract Gears
with the Accumulator
Dial Gears, depress and hold the Plus Bar.
Sight under
the Carriage from either
the right or the left and observe
the depth of engagement
the Add
- Subtract Gears
have with the Dial
Gears.
Next depress
the Minus
Key and again sight for the amount
of mesh the Add
- Subtract Gears
have with the Dial Gears.
The depth of meshing
should be approximately
equal.
If one
side meshes
too deep, adjust at Nut A.
If the Gate
throw
is limited
or the
Plus
or Minus
Key binds,
check Adj. 40H,
51B, 60E.
NOTE:
The Cycle Lock
Pin should clear the Cycle Lock Disc in Plus and Minus,
Fig. 2.
Do not
adjust at Nut A to obtain this clearance.
Re-check
Adj. 40A.
Advertisement
Table of Contents
Need help?
Do you have a question about the STW-ACG and is the answer not in the manual?