Summary of Contents for Get Packed M-1000
- Page 1 Auto Tape Dispenser I n s t r u c t i o n M a n u a l Thank you very much for purchasing “Auto Tape Dispenser“. Please read this instruction manual before using or when it’s necessary.
-
Page 2: Table Of Contents
Contents Caution ........................................Notice Warning Do NOT put flammable onto the unit. Caution ........................................Description of Do NOT use the unit under unsteady place. parts and function ........................................0peration Setting up Do NOT use the unit in humid or dusty place. Loading tape Sets tape length Do NOT disassemble or modified the tape dispenser. -
Page 3: Description Of For Parts And Function
Description of parts and function 0peration Setting up For M-1000 Fuse Reel Make sure power and sensor Control panel switches are OFF for safety purpose Attention Control panel TAPE LENGTH Feed roller Plug sensor plug into the unit. Pressure knob... -
Page 4: Sets Tape Length
3.5 Using automatic feed Adjust “Pressure knob” in accordance with tape. Remove a piece of tape If tape curls up or slips, Turn sensor switch ON. increase pressure.( clockwise ) Soft Hard If tape creases, Tape will be fed set length and cut. decrease pressure.( counter clockwise ) Remove a piece of tape from machine Cut key... -
Page 5: How To Removejammed Tape
3.8 How to removejammed tape 4.2 Maintenance of cutter blades Although special coating is applied on Press “ ” to reverse tape. ( Fig.) NSA cutter blade, glue will be built up ※Hold the tape and wind it backward Wind the tape backward slightly slightly as per ( Fig. -
Page 6: Speci Cations
4.4 Replacing fuse Turn main power OFF and pull power cord out. Turn fuse holder lid to counter clockwise by - screw driver. Power switch Replace fuse. Fuse Put fuse holder lid back and turn it to clockwise by - screw driver. Speci cations M-1 0 0 0 Model No.
Need help?
Do you have a question about the M-1000 and is the answer not in the manual?
Questions and answers