Page 1
Long-Frame Floor Jack Installation and Operation Manual Manual P/N 5900074 — Manual Revision B — August 2018 Model: • RFJ-10TL ⚠ Read the entire contents of this manual before using this product. Failure to follow the instructions and safety precautions in this DANGER manual can result in serious injury or death.
Page 2
Feel free to contact us at any time to get the latest information about any product: rangerproducts.com Warranty. The BendPak Ranger warranty is more than a commitment to you: it is also a commitment to the value of your new product. For full warranty details and to register your new BendPak Ranger product, contact your nearest BendPak Ranger dealer or visit www.bendpak.com/support/warranty.
Parts Breakdown Introduction This manual describes the RFJ-10TL Long Frame Floor Jack, a long-chassis garage floor jack that can raise up to 20,000 lbs. (9,072 kg, 10 tons) over 23 inches (584 mm) high. More information about the full line of Ranger Products is available at rangerproducts.com.
BendPak Ranger assumes no liability for damages resulting from: • Use of the product for purposes other than those described in this manual. • Modifications to the product without prior, written permission from BendPak Ranger. • Damage to the product from external influences. •...
Lock Positions: Lets you lock the Handle at a different angle; good for towing. • Foot Pump: Lets you pump the Jack using your feet. • Bolt: Locks the Handle in position. RFJ-10TL Long-Frame Floor Jack P/N 5900074 — August 2018 — Rev. B...
Only use the Jack on a hard, flat, dry surface. Only lift one side or end at a time. Make sure the Vehicle does not have any people in it. The following drawing shows the Lock/Release mechanism. RFJ-10TL Long-Frame Floor Jack P/N 5900074 — August 2018 — Rev. B...
Page 7
Make sure there is nothing else under the Vehicle. If there is, move it out of the way. 5. Move the Control Rod to the Lowering Position. 6. When the Vehicle is securely on the ground, move the Jack out from under it. RFJ-10TL Long-Frame Floor Jack P/N 5900074 — August 2018 — Rev. B...
Jack feels “spongy” when lifting. Remove air from the Hydraulic System. If you continue to have problems with your Jack, call Ranger Products at (805) 933-9970 or visit www.bendpak.com/support/. RFJ-10TL Long-Frame Floor Jack P/N 5900074 — August 2018 — Rev. B...
Parts Breakdown RFJ-10TL Long-Frame Floor Jack P/N 5900074 — August 2018 — Rev. B...
Page 10
Screw Wheel 2.12 Washer Grease fitting 2.13 Washer Roller 2.14 Clamp ring Stop ring 2.15 Bush Split ring Power unit Joint 3.23 Cotter pin Screw 3.24 Connecting rod RFJ-10TL Long-Frame Floor Jack P/N 5900074 — August 2018 — Rev. B...
Page 11
Screw 6.18 Spring Saddle Saddle carrier Axle Level supporting rod Axle Rocker Bolt Axle Axle 7.10 Grease fitting 7.11 Split ring Cover plate Side plate Screw Washer Washer RFJ-10TL Long-Frame Floor Jack P/N 5900074 — August 2018 — Rev. B...
Need help?
Do you have a question about the RFJ-10TL and is the answer not in the manual?
Questions and answers