Advertisement
Quick Links
V150e Quick Installation Guide
1. Upper Mount
Normal structure / Side-beam structure
① Drill holes on the ceiling or on the side of the crossbeam. The position of the
drill holes must fit the installation holes of the upper mount. Use a ф12mm drill
bit to reach a depth of 60-70mm, then fix 2 to 4 expansion bolts (M10*80) on
each side, and finally fix the upper mount with nuts (see Figure 1.1)
Figure. 1.1
I-beam structure / Round-tube structure
① using two M10*100 hexagonal bolts and nuts each side to fix the upper
mount (see Figure 1.2 and 1.3)
Figure. 1.2
Figure 1.3
1
Advertisement
Summary of Contents for Hamilton Air V150e
- Page 1 V150e Quick Installation Guide 1. Upper Mount Normal structure / Side-beam structure ① Drill holes on the ceiling or on the side of the crossbeam. The position of the drill holes must fit the installation holes of the upper mount. Use a ф12mm drill bit to reach a depth of 60-70mm, then fix 2 to 4 expansion bolts (M10*80) on each side, and finally fix the upper mount with nuts (see Figure 1.1)
-
Page 2: Extension Tube
V150e Quick Installation Guide 2. Controller ① Insert the controller into the hollow frame of the upper mount. The power cord, motor wire, and LED light wire (optional) of the controller are led out from the end shown in Figure 2 ②... - Page 3 V150e Quick Installation Guide ② Unscrew two M4*10 hexagonal screws near the upper end of the extension tube, and install the lower decorative cover from the upper end to the lower end, and then install the upper decorative cover (see Figure 3.2) ③...
- Page 4 V150e Quick Installation Guide ⑤ Connect the 4-core motor connection wire on the controller with the one on the extension tube, buckle the plastic plug (see Figure 3.5) ⑥ Connect the 2-core LED light connection wire on the controller with the one on the extension tube, buckle the plastic plug (optional, see Figure 3.6)
- Page 5 V150e Quick Installation Guide 4. Motor ① Insert the motor into the extension tube, align their installation holes. Then use two M8*65 hexagonal bolts, flat washers, spring washers, and M8 nylon locking nuts to tighten the structure (see Figure 4.1) Figure.
- Page 6 V150e Quick Installation Guide ⑤ Push the lower decorative cover downward to cover the installations on motor shaft, where there are two pre-installed M4*10 hexagonal screws on extension tube that prevent the lower cover from sliding down. Please be aware there should be a gap between the cover and the motor (see Figure 4.3)
-
Page 7: Controller Wiring Diagram
V150e Quick Installation Guide 6. Overall Inspection After installing all the blades, please check the following items: ① The levelness of the fan. If a serious tilt happens in extension tube or fan blades, it is necessary to use a spirit level to readjust the position;... -
Page 8: Remote Control
V150e Quick Installation Guide 8. Remote control Turn on the power supply under safe condition, when the controller make a long beep sound, the remote control can then be used. See the below instruction.
Need help?
Do you have a question about the V150e and is the answer not in the manual?
Questions and answers