Subscribe to Our Youtube Channel
Summary of Contents for Rossi WLDHMTROSASFS
- Page 1 Solar Auto-Welding Helmet User Manual [Revision 2.0 December 2018] RETAIN THIS MANUAL FOR FUTURE REFERENCE PLEASE READ THIS MANUAL CAREFULLY BEFORE USE...
-
Page 2: Table Of Contents
Solar Auto-Welding Helmet Table of Contents Safety ..................................1 Parts Diagram ................................2 Helmet ................................2 Welding ................................. 3 Operation ..................................3 Before Welding .............................. 3 Shade Number Selection ..........................4 Headband Adjustment ........................... 4 Battery Replacement ............................. 4 Maintenance ................................5 Troubleshooting ............................... -
Page 3: Safety
Solar Auto-Welding Helmet Safety • The welding helmet is not suitable for laser and oxygen acetylene welding operations. • Do not store the welding helmet and filter near sources of high heat or in damp places. • Do not remove the filter from the welding helmet or open the filter box on your own. •... -
Page 4: Parts Diagram
Solar Auto-Welding Helmet Parts Diagram Helmet No. Part No. Part Helmet body Solar panel Headgear Fixed plate Headgear adjusting knob Press card Headgear angle adjusting knobs UV/IR filter Shade number adjuster Protection plate buckle Protective plate... -
Page 5: Welding
Solar Auto-Welding Helmet Welding No. Part No. Part Solar cell Arc sensor UV/IR filter Operation Before Welding • Please check if the protective film has been removed from the internal and external screen. • Please check if there is sufficient power before using. •... -
Page 6: Shade Number Selection
Solar Auto-Welding Helmet Shade Number Selection • Shade number can be manually set from 9-13 by rotating the adjusting knob to set the proper shading number. The adjusting knob is on the outside/inside of the mask, • Adjust the helmet to the correct shade for the welding process by referring to the table below. Headband Adjustment •... -
Page 7: Maintenance
Solar Auto-Welding Helmet Maintenance • Please use tissues, lens paper or clean, soft cotton balls when cleaning the filter. • Please use a chemically-neutral detergent to clean the welding helmet shell and sweat bands. • Replace the external/internal protection plates and sweat bands regularly. •... -
Page 8: Technical Specifications
Solar Auto-Welding Helmet Technical Specifications Optical class 1/2/1/2 Viewing area 90x35mm Cartridge size 110x90x9mm Arc sensor Light state DIN4 Dark state Variable shade, 9 – 13 Shade control External, variable Power On/Off Fully automatic Sensitivity control Not adjustable, auto UV/IR protection DIN16 Solar cell. - Page 9 ©2018 Rossi. All rights reserved. No part of this document, including descriptive content, concepts, ideas, diagrams or images may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, scanning or recording, or any information storage and retrieval system, without express permission or consent from the publisher.
Need help?
Do you have a question about the WLDHMTROSASFS and is the answer not in the manual?
Questions and answers