Strike Universal Tablet Cradle User Manual

Universal Tablet Cradle User Manual
ADJUSTING SIZE
1 2
Loosen the 4 Insert device and
adjust height to t
front-facing screws
device without any
tension on springs
INSERTING DEVICE
1
Insert device at a
slight angle into the
spring-loaded end
ADDING FOAM SPACERS
This is recommended if you are using a
device that will be sitting ush against
the back of the cradle, especially if it is
not in a protective case.
1) Peel the foam spacer o the paper sheet
2) Stick the spacers in the areas shown
INSTALLING SLIDING CHOCK
The chock is helpful to stabilise the device of any
forward and backward movement.
1
The chocks can be used to hold
the device toward either the
front or the back of the jaws. The
curved, rubberised side should
be directed toward the device.
3
With device installed, slide
chock so it is rm up against
it, and fully tighten screw.
Strike Group Australia Pty Ltd
1/263 Toombul Rd, Northgate QLD, Australia 4013
3
Slide device out the side
of the cradle
2
Use the device
to push the
spring-loaded
end upward
2
Install chock into recessed
channel of jaw, xing in place
from the other side with the
screw provided in Bag B2. Do
not fully tighten; the chock
should still slide.
4
Reduce height by
approximately 1.5cm
3
Pivot the base
of the device
inward once it
has cleared the
bottom lip
CHANGING JAWS
1
Remove
rear-facing
screw
INSTALLING SIDE SUPPORT
If using the cradle in landscape, or side support is required for any
reason, side supports are included in Bag C.
1
Place the
bracket at the
desired length,
ensuring the
rear slots line up
with the
mounting holes
on the rear of
the cradle
www.strike.com.au
5
Tighten 4
front-facing screws
4
Lower the device
into the bottom
set of jaws
There is a larger set of jaws for devices
that are too thick for the regular jaws.
2
Remove jaw
3
Install the XL jaw
using the same
screw that was
removed in Step 1
2
Insert and
tighten
screws
provided
(Bag C2)
sales@strike.com.au
1300 792 044
4
Repeat for the
other 3 jaws