Advertisement
Quick Links
Advertisement
Related Manuals for Essity TENA SMARTCARE Change Indicator
Summary of Contents for Essity TENA SMARTCARE Change Indicator
- Page 1 Quick Guide For professional caregivers Version EU: 2023-11-30...
- Page 2 Important information The TENA SmartCare Change Indicator is intended for use with TENA absorbent product. Clean the Change Indicator when fully assembled to prevent water from entering the device. Do not submerge in water or clean in a washing machine.
-
Page 3: Set Up The System
Components Set up the system The Change Indicator transmits information to the TENA SmartCare Professional app and web portal via gateways installed in Care recipients’ rooms and common areas. To start use the Change Indicator, the system should be set up in the TENA SmartCare GATEWAY SENSOR STRIP web portal. - Page 4 Assemble the Change Indicator REMOVE PROTECTION LID + INSERT THE BATTERY ASSEMBLE THE CHANGE INDICATOR (TRANSMITTER + SENSOR STRIP) Press firmly until there is a click! If Protection lid is attached, remove it using a battery. The Protection lid can be used Angle the Press firmly when storing or cleaning the transmitter.
- Page 5 Attach the Change Indicator to product FIND THE FRONT ALIGN WITH THE TOP OF THE PLACE TIGHTLY APPLY THE ABSORBENT PRODUCT THICKER ABSORBENT AREA WITH THE CHANGE INDICATOR TO THE CARE RECIPIENT TENA Slip tch Brief / Press firmly! Tight fit all the way TENA Pants FRONT...
- Page 6 Attach the Change Indicator to product FIND THE FRONT ALIGN WITH THE TOP OF THE PLACE TIGHTLY APPLY THE ABSORBENT PRODUCT THICKER ABSORBENT AREA WITH THE CHANGE INDICATOR TO THE CARE RECIPIENT TENA Flex TENA Flex FRONT Press firmly! Tight fit all the way TENA Comfort Press firmly!
- Page 7 Use the Change Indicator PRESS BUTTONS APPLY THE TENA PRODUCT FOLLOW NOTIFICATIONS CONSIDER CHANGE Press both buttons for 2 seconds Steady green light for a few seconds = Apply on the care recipient. SOME URINE CONSIDER CHANGE Change is registered, –...
- Page 8 Remove and clean Remove/ Replace strip REMOVE THE CHANGE INDICATOR CLEAN WHEN ASSEMBLED Replace the sensor strip every 12 weeks or when it cannot be cleaned. Insert the battery into the Twist battery to remove slot on the transmitter. transmitter from strip. Remove the Change Indicator before Only clean when assembled.
- Page 9 Replace battery Clean transmitter for reuse NEW CARE RECIPIENT CLEAN TRANSMITTER Battery lasts for approximately 12 weeks of use. Clean transmitter in-between use on different care-recipients. If the light starts blinking Click! with a white light during use, either the battery needs to be replaced or the transmitter is not properly attached to the sensor strip.
- Page 10 Clean transmitter for reuse NEW CARE RECIPIENT CLEAN TRANSMITTER Clean transmitter in-between use on different care-recipients. Remove protection lid and use on new care recipient.
- Page 11 TENA Professional app (Help > Instruction for use) and the TENA SmartCare web portal smartcarepro.tena.com If you have questions or need support, contact your TENA representative www.tena.com Essity Hygiene and Health AB SE-405 03 Göteborg, Sweden Visiting address: Mölndals Bro 2, Mölndal www.essity.com...
Need help?
Do you have a question about the TENA SMARTCARE Change Indicator and is the answer not in the manual?
Questions and answers