Summary of Contents for ATS ATS-W-80A-1
- Page 1 Please, read this manual Owner’s Manual carefully before use! Automatic Transfer Switch (ATS) DOMESTIC ATS-W-80A-1 240 VOLT SINGLE PHASE MA1-80D ATS-W-95A-3 415 VOLT THREE PHASE MA3-95D...
- Page 2 - Make sure there are no foreign objects on the product when it is turned on. - Do not overload the product; use it for its intended purpose only. PLEASE NOTE! The total power of power consumers connected to the ATS system must not exceed the maximum permissible power for this ATS unit model.
-
Page 3: Specifications
ATS unit checks within 12 seconds (time can be programmed) whether there is voltage. If the power supply is not restored, the ATS starts the generator, warms up the engine for 6 seconds (time can be programmed) and supplies power from the generator to power consumers. - Page 4 GENERAL VIEW OF THE ATS UNIT 1. Programmable controller 2. Control cable connector (Charger or ATS signal) 3. Cable entry openings...
- Page 11 -10-...
-
Page 12: Circuit Diagram
MA1-80D CIRCUIT DIAGRAM -11-... - Page 13 MA3-95D CIRCUIT DIAGRAM -12-...
- Page 14 Connection of the generator and ATS to the building power supply network: CONNECTION DIAGRAM GENERATOR WITH ATS ELECTRICAL SUPPLY NETWORK ELECTRICITY CONSUMERS -13-...
- Page 15 ESTABLISHED 1949 POWER ANYWHERE, ANYTIME! MELBOURNE I SYDNEY I BRISBANE I PERTH 1300 MAC GEN (1300 622 436) www.macfarlanegenerators.com.au I info@macgen.com SALES I SERVICE I SPARES I HIRE I NEW I USED...
Need help?
Do you have a question about the ATS-W-80A-1 and is the answer not in the manual?
Questions and answers