the t.bone free2b Quick Start Manual

Quick start guide
This document contains important information on the safe use of the product. Read and follow the safety instructions and all other instruc-
tions. Keep the document for future reference. If you pass the product on to others, please include this document.
Contents are subject to change. Please refer to the latest version of the documentation, which is available for download at www.thomann.de.
Safety instructions
Intended use
This device is used for the wireless transmission of audio signals
with microphone and line level. Any other use or use under other
operating conditions is considered to be improper and may result in
personal injury or property damage. No liability will be assumed for
damage resulting from improper use.
This device may be used only by persons with sufficient physical,
sensory, and intellectual abilities and the necessary knowledge and
experience. Other persons may use this device only if they are su-
pervised or instructed by a person who is responsible for their safety.
Risk of injury and choking hazard for children!
Children can suffocate on packaging material and small
parts. Children can injure themselves when handling the de-
vice. Never allow children to play with the packaging material
and the device. Always store packaging material out of the
reach of babies and small children. Always dispose of pack-
aging material properly when it is not in use.
Never allow children to use the device without supervision.
Keep small parts away from children and make sure that the
device does not shed any small parts (such as knobs) that
children could play with.
Risk of injury due to incorrect handling of lithium batteries!
In the event of a short circuit, overheating or mechanical
damage, lithium batteries can cause severe injuries. Handle
lithium batteries in a correct and professional manner. Store
lithium batteries in a cool and dry place in their original pack-
aging. Keep lithium batteries away from sources of heat. Nev-
er open lithium batteries. Only charge rechargeable lithium
batteries with a suitable charger. Remove the lithium batter-
ies before disposing of the device. Cover the poles of used
lithium batteries with adhesive tape to prevent short circuits.
Electrolyte can escape from damaged lithium batteries. Put
the damaged lithium battery in air-tight packaging. Collect
the electrolyte with absorbent paper. Wear rubber gloves
while doing so.
Features
ƒ Plug-on system for dynamic microphones
ƒ Transmitter and receiver set ready for use
ƒ Auto-pairing
ƒ 2.4-GHz band suitable for license-free operation worldwide
ƒ 24 bit/44.1 kHz high-resolution audio quality
Interference with neighbouring electrical receivers due to electro-
magnetic field!
The device emits an electromagnetic field during operation.
Using the device near receiver devices (e.g. radios or TV
sets) may cause interference. If the device interferes with
neighbouring receivers during operation, increase the dis-
tance between the device and the receivers experiencing
interference.
Damage to the device if operated in unsuitable ambient condi-
tions!
The device can be damaged if it is operated in unsuitable
ambient conditions. Only operate the device indoors within
the ambient conditions specified in the "Technical specifi-
cations". Avoid operating it in environments with direct sun-
light, heavy dirt and strong vibrations. Avoid operating it in
environments with strong temperature fluctuations. If tem-
perature fluctuations cannot be avoided (for example after
transport in low outside temperatures), do not switch on the
device immediately. Never subject the device to liquids or
moisture. Never move the device to another location while it
is in operation. In environments with increased dirt levels (for
example due to dust, smoke, nicotine or mist): Have the de-
vice cleaned by qualified specialists at regular intervals to
prevent damage due to overheating and other malfunc-
tions.
General handling
ƒ To prevent damage, never exert force while operating the
device.
ƒ Never immerse the device in water. Wipe only with a clean and
dry cloth. Do not use liquid cleaners such as benzene, thinners or
flammable cleaning agents
Keep the device away from impurities!
Keep the device away containers with liquid. Should liquid enter the
device, this could lead to its destruction or fire. Ensure that no metal-
lic parts enter the device.
ƒ Built-in lithium-ion battery
ƒ Charging via supplied micro-USB cable
ƒ LED display for charging state and selected channel group
ƒ Adapter from XLR to 3.5-mm mini jack included
EN
free2b