Gorilla 84016 Quick Start Manual

Important: Read safety information and instructions inside before
using glue gun. Save all instruction sheets for future reference.
84015A Dual Temp / Mini Size / Glue Gun
Dual Temperature for High and Low temperature bonding.
High Temp: For Strong Bonding like Wood, Plastic, Metal, Glass & More
Low Temp: For Delicate Materials like Floral, Fabric, Foam, Jewelry & More
inlet Tube Side Fins
— Feeder Tube
rowerticnt © EMhanced Safety Features
Safety Fuse: Shuts the glue gun off
automatically in the event of a short.
Side Fins: Allows glue gun to lay safely
RubberHandle on its side, preventing glue back up.
Insulated Nozzle: Helps safeguard against
burns.
insulated Nozzle
High (H) / Low (L)
Temp Switch
AX WARNING
When using electric tools, basic safety precautions should always be followed to reduce the risk of fire,
electric shock and personal injury. This appliance has a polarized plug (one blade is wider than the other).
Rubber ne eee
To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
Do not modify this plug in any way.
A\ WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
Safety Information
1. Work environment should be clean, dry, well lit and clear of flammable materials.
2. Do not use outdoors or near water.
3. Do not expose glue gun to rain, moisture or direct sunlight.
4. Keep away from children and pets and store out of reach when not in use.
5. Do not carry glue gun by cord or unplug from outlet by pulling electrical cord.
6. Disconnect glue gun when not in use.
7. Glue gun is on when plugged in. Do not leave unattended.
8. Do not use hot melt glue to replace structural fasteners.
9. Do not use extension cords.
10. Do not use any material other than recommended glue sticks.
11. Avoid accidental discharge. Do not touch glue stick or trigger unless intending to dispense glue.
Feeding or pushing glue stick with too much force into heated gun may cause hot glue to be
unexpectedly expelled from nozzle or to flow back from inlet tube.
12. Allow glue gun to cool completely before storing.
13. Save these Safety Instructions for future reference.