• If the power cord is damaged, it must be replaced by a recommended qualified technician in order to avoid a hazard. • HOST recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).
Page 3
• HOST recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.
Ensure the side brackets are postponed on the inside of the marble rim. 4. Push the side brackets flush with the marble and tighten the bracket screws. HOST1310PR (HOST1311CR & HOST1312ST)_EN_A5_v1_20220819.indb 4 HOST1310PR (HOST1311CR & HOST1312ST)_EN_A5_v1_20220819.indb 4 2022/8/19 14:47 2022/8/19 14:47...
Fit Glass Panels HOST1312ST (HOST1310PR Only) Storing Food 1. Screw the collars to the rim of the appliance. To get the best results from your HOST appliance, Note: Ensure the hole in the collar for the follow these instructions: grub screw faces inwards.
Switch off and disconnect from the power • Failure to clean the condenser filter will reduce supply before cleaning. the performance and life of your HOST unit and may invalidate your warranty. • Clean the interior of the appliance as often as •...
Check and tighten all nuts and screws unusually loud The appliance has not been Check installation position and change if installed in a level or stable position necessary HOST1310PR (HOST1311CR & HOST1312ST)_EN_A5_v1_20220819.indb 7 HOST1310PR (HOST1311CR & HOST1312ST)_EN_A5_v1_20220819.indb 7 2022/8/19 14:47 2022/8/19 14:47...
Service Should your appliance have a fault, please visit the Service section of the HOST website. Technical Specifications Model Voltage Power Current Temperature Range Refrigerant HOST1310PR 230V 50Hz 230W 1.6A 2°C - 8°C R600a 100g (HOST1311CR (HOST1311CR) (HOST1311CR) (HOST1311CR) &...
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of HOST. Every effort is made to ensure all details are correct at the time of going to press, however, HOST reserve the right to change specifications without notice.
Page 10
DocuSign Envelope ID: 9A78D6AA-FE74-465B-AE5A-DDBC90ABE0BA UKCA Declaration of Conformity {Host} {Host House, Newhouse Farm Industrial Estate, Mathern, Chepstow, NP16 6UP} hereby declare that the equipment is in conformity with the requirements of the following Regulations: Supply of Machinery (Safety) Regulations 2008 ...
Need help?
Do you have a question about the HOST1310PR and is the answer not in the manual?
Questions and answers