Page 4
Read the Safety Warning in the User Guide and the decals of the generator set carefully.
Page 5
Guide Do not use indoors Do not use in humid environment Do not connect it to utility Do not smoke when refueling power system directly Shut down the generator Do not spill when refueling before refueling...
Page 9
take following counter measures: overload cuts out To operate the DC output again, press DC switch to "ON" position. Outputs normally. If DC protection is in off status, reduce the load of electronic device connected to rated output current and ensure it’s in ON position. If DC output is still in off status, stop using electronic device directly and consult with...
Page 10
(ECO Switch) When using inductive appliances such as air compressor and submersible pump , unscrewing counterclockwise. (AC Reset) cut out output. appliance...
Engine does not start Is there petrol in the Tank? Add petrol Is the engine circuit Ensure engine circuit continuity switched ON? Is there sufficient oil? Add recommended oil? Is the fuel tap in the ‘on’ Turn the fuel tap to the ‘on’ position? position Does a spark occur in the...
Page 26
Connected device does not work Digital display shows 240v Overload indicator illuminates? Get in contact with the dealer Shutdown and press AC reset Check if device is faulty button to ON position then restart generator. Overload indicator still illuminates? -Replace your device -Have your device repaired Get in contact with the dealer Power Insufficient...
YOUR RECEIPT MUST BE RETAINED AT ALL TIMES FOR WARRANTY. Responsibilities of The Consumer Under This Warranty Deliver or ship the REDBACK Generator covered under this warranty to iTechworld. 12-month warranty or 500 hours whichever comes first. Not for commercial use, domestic use only.
Need help?
Do you have a question about the RB3.5 and is the answer not in the manual?
Questions and answers