Zagg pro keys Manual

Inserting Your Device

Holding your device in landscape mode with the volume control buttons facing up, press the top half of your device into the case and apply light pressure to snap it snuggly into place. Press the bottom half of your device into the case and check each corner to make sure your device is seated properly.

Attaching the Keyboard with Magnetic, Foldable Flap

Attach the case to the keyboard by setting the case in one of the two cradles on the keyboard (above the keys). Place the top of the magnetized, foldable back flap against the top of the back of the case. You'll feel it magnetically snap into place. This should create a triangular stand at the base of the flap that props up your tablet in the case.

Detaching the Case from the Keyboard

Simply pull the magnetized back flap away from the case.

Removing Your Device

Hold on to the top lip of the case and press against the back of the case. Then, grasp the exposed side of your device and lift/pull it away from the cover.

Powering On/Off

Press the Power button to turn your Pro Keys keyboard on. A green LED will light briefly. Press and hold the Power button for three seconds to turn your Pro Keys keyboard off. A red LED will flash indicating it has turned off.

Pairing the Keyboard with Your Device

Verify your device's Bluetooth^® settings are on. Press and hold Pro Key's Bluetooth 1 button for three seconds. A blue LED under the Power button will flash until pairing is complete. Select "ZAGG Pro Keys" from your device's list of available devices to complete pairing.

To pair a second device, press and hold the Bluetooth 2 button for three seconds, and follow the same procedure.

Charging Your Keyboard

Plug the Type-C end of the charging cable into the keyboard and the other USB end into your preferred USB charging outlet. A red LED light on the battery key will illuminate to show that your keyboard is charging. When this light turns off, your Pro Keys keyboard is finished charging. Disconnect the charging cable.

Disconnecting Your Keyboard

First, detach the keyboard from the case.
See previous instructions.

There are three ways to switch to your onscreen keyboard:

1. Press the Keyboard Hide/Show button.
2. Turn off the Bluetooth connection from your device.
3. Turn the Pro Keys keyboard off.
   

Checking Your Battery Level

To check your Pro Keys' battery life, press fn + the battery key. The LED light will flash one of the following three ways:

• 3 green flashes = 50% or more battery life
• 2 yellow flashes = 25-49% battery life
• 1 red flash = less than 25% battery life
  

Toggle Trackpad On & Off

TURN ON: Press the Function key (Fn) and the left cursor simultaneously.

TURN OFF: Press the Function key and the left cursor again.

Trouble Shooting

If your device doesn't respond to Pro Keys, there may be a simple explanation.
Try the following steps.

1. Restart your device.
2. Turn your Pro Keys off and back on.
3. Forget and re-pair your Pro Keys.
4. If your Pro Keys does not establish or maintain a Bluetooth connection, reset the Bluetooth module by charging your keyboard.
5. If, after charging, your keyboard doesn't operate correctly, please contact ZAGG Customer Service.

If you still experience problems, please contact ZAGG Customer Service.

zagg.com/support/contact.php

questions@ zagg.com

1-800-700-ZAGG [9244]

00-1-801-839-3906 for international customers

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Zagg pro keys Manual