Page 1
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means - electronic, mechanical, photocopying, recording, or otherwise - without prior written permission of Safety-Kleen Systems, Inc.
ABLE OF ONTENTS Safety Measures ______________________________________________________ 2 Safe Use Instructions __________________________________________________ 2 The Equipment _______________________________________________________ 4 Specifications ________________________________________________________ 4 Site Requirements ____________________________________________________ 4 Operating Controls ____________________________________________________ 6 Operation ___________________________________________________________ 6 Service and Repair ____________________________________________________ 9...
SDS within easy reach. The Safety-Kleen cleaning fluid and other additives provided by Safety-Kleen are the ONLY cleaning agents intended for use in this equipment. The use of any other cleaning agents could cause a hazardous condition over which Safety-Kleen has no control and which will void equipment warranty.
Page 5
Safety-Kleen Systems, Inc. Model 1077 Operator’s Booklet 8. CANADA ONLY: Unit must be installed in a well-ventilated area with a dedicated air supply hose. Air mover must be vented directly outdoors with exhaust at a minimum of 12 feet (3.6m) from the outside grade.
The Model 1077 Gun Cleaner consists of a wash bowl with two foot pedal activated spigots - one for clean and the other for recirculated cleaning fluid. The Model 1077 also includes a Blow- Out Funnel, which is located between the spigots. When cleaning the inside of a spray gun, connect the spray gun to an air line and blow out the remaining residue through the funnel.
See Figure 1 for appropriate distances for placement. The Model 1077 Gun Cleaner can be placed in locations classified as Class 1, Division 1/Zone 1. If the Model 1077 Gun Cleaner is installed in locations classified as Class 1, Division 2/Zone 2, or in unclassified locations, the area within 5 feet from the unit is to be classified as Class 1, Division 1/Zone 1.
PERATING ONTROLS There are four control components used in the operation of the Model 1077 Gun Cleaner which are described below (see Figure 1). Air Control Valve: Used to turn the machine “ON” and “OFF.”...
Safety-Kleen Systems, Inc. Model 1077 Operator’s Booklet PERATION 1. Detach the air hose from the paint gun. 2. Separate the paint cup from the spray gun head. 3. Drain as much paint as possible from the paint cup into a properly labeled waste paint container.
Safety-Kleen Systems, Inc. Model 1077 Operator’s Booklet 13. Use clean cleaning fluid to clean the outside of the nozzle (gun tip), air cap, and the paint cup. 14. The clean fluid spray can be altered by adjusting the airflow with the knob on the right side of the gun cleaner.
Install and set up the Safety-Kleen equipment • Be your primary contact with Safety-Kleen • Put the name and phone number of the nearest Safety-Kleen branch on the equipment and/or on the inside cover of this booklet • Provide information about your service contract with Safety-Kleen •...
Page 12
Safety-Kleen Systems, Inc. 2600 North Central Expressway Suite 400 Richardson, TX 75080 Printed in USA Rev. 06/2015 817295...
Need help?
Do you have a question about the 1077 and is the answer not in the manual?
Questions and answers