JML Handy Brite Solar LED Spotlight Pro User Manual

WHAT'S INCLUDED
1. SOLAR PANEL
1. Solar Panel
2. Adjustable Arm
3. Mount
4. Motion Sensor
5. Mode Switch
6. Ground Stake
7. Mounting Hardware
6. GROUND
STAKE
Bottom
Section
Top
Section
4. MOTION
SENSOR
7. MOUNTING
HARDWARE
Screws:
(3)
Anchors:
(3)
INSTALLATION
NOTE: PRIOR TO INSTALLING, BE SURE MODE SWITCH IS IN MOTION MODE.
USING THE MOUNT
1. Remove the Mount (3) from Handy Brite™by
turning ring counterclockwise until it comes
apart from unit.
5. MODE
2. Hold the Mount (3) against your desired surface, and mark the
SWITCH
holes with a pencil. Drill pilot holes when you are sure of placement.
3. Attach the Mount (3) to the surface using the
2. ADJUSTABLE
included hardware.
ARM
4. Position the arm of the Handy Brite™ over the
Mount (3), and twist ring clockwise until tight.
5. Adjust the angle of the light for
best coverage, and adjust the
3. MOUNT
solar panel to receive maximum
light exposure.
USING THE GROUND STAKE
1. Keep Mount (3) attached to your Handy Brite™
2. Insert the spike section of the
Ground Stake (6) into the ground first.
3. Attach top section of Ground Stake (6)
on top of spike.
4. Position Handy Brite Mount (3) over
the Ground Stake (6) and push down
gently until secure.
5. Adjust the angle of the light for
best coverage, and adjust the
solar panel to receive maximum
light exposure.