Table of Contents
Advertisement
Quick Links
TV-Free
Video-in-motion Interface
TF-MFD2
Compatible with Audi RNS-E,
Volkswagen MFD2/RNS2
and Skoda Nexus
navigation systems
Legal Information
By law, watching moving pictures while driving is prohibited, the driver must not be
distracted. We do not accept any liability for material damage or personal injury resulting,
directly or indirectly, from installation or operation of this product. This product should only
be used while standing or to display fixed menus or rear-view-camera video when the
vehicle is moving, for example the MP3 menu for DVD upgrades.
Changes/updates of the vehicle's software can cause malfunctions of the interface. We
offer free software-updates for our interfaces for one year after purchase. To receive a free
update, the interface must be sent in at own cost. Labor cost for and other expenses
involved with the software-updates will not be refunded.
Version 05.04.2024
TF-MFD2
Advertisement
Table of Contents
Summary of Contents for CAS TF-MFD2
- Page 1 TV-Free Video-in-motion Interface TF-MFD2 Compatible with Audi RNS-E, Volkswagen MFD2/RNS2 and Skoda Nexus navigation systems Legal Information By law, watching moving pictures while driving is prohibited, the driver must not be distracted. We do not accept any liability for material damage or personal injury resulting, directly or indirectly, from installation or operation of this product.
-
Page 2: Table Of Contents
1.1. Delivery contents Take down the SW-version and HW-version of the interface boxes, and store this manual for support purposes. CAN-box TV-500 Harness HW_____ SW_____ TV-VN01 Version 05.04.2024 TF-MFD2... -
Page 3: Check Compatibility Of Vehicle And Accessories
Dip 1 – activation TV-free Dip 2 – no function Dip 3 – no function Dip 4 – no function Dip 5 – CAN-bus termination resistor on the vehicle side Dip 6 – CAN-bus termination resistor on the head-unit side Version 05.04.2024 TF-MFD2... -
Page 4: Pin-Assignments
Switch off ignition and disconnect the vehicle’s battery! If according to factory rules disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle in sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a resistor lead. Version 05.04.2024 TF-MFD2... - Page 5 2. Disconnect Quadlock connector from the backside of the navigation computer and connect it to harness TV-VN01. If the original Quadlock connector carries 12pin inserts, disconnect the inserts and connect them to harness TV-VN01. Connect TV-VN01 to the navigation computer. Version 05.04.2024 TF-MFD2...
-
Page 6: Activation Of The Video-In-Motion Function
Connect a switch to the green cable and connect the green cable to +12V ACC. ● +12V = TV-Free is activated ● = TV-Free is not activated Note: The loose white cable is not required and must be isolated. Version 05.04.2024 TF-MFD2... -
Page 7: Specifications
Temperature range -30°C to +80°C Weight Measurements (box only) W x H x D 76 x 27 x 54 mm 5. Technical Support CAS GmbH manufacturer/distribution In den Fuchslöchern 3 D-67240 Bobenheim-Roxheim email support@casgermany.com Legal disclaimer: Mentioned company and trademarks, as well as product names/codes are registered trademarks ®...
Need help?
Do you have a question about the TF-MFD2 and is the answer not in the manual?
Questions and answers