Welcome to Electrolux! Thank you for choosing our appliance. Get usage advice, brochures, troubleshooting, service and repair information: www.electrolux.com/support Subject to change without notice. CONTENTS 1. SAFETY INFORMATION................2 2. SAFETY INSTRUCTIONS................4 3. PRODUCT DESCRIPTION................6 4. TECHNICAL DATA..................7 5.
• Children between 3 and 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised. • Children of less than 3 years of age should be kept away from the appliance unless continuously supervised.
• The appliance must be connected to the water mains using the new supplied hose sets, or other new hose sets supplied by the Authorised Service Centre. • Old hose sets must not be reused. • If the mains power supply cable is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard.
2.4 Use • Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power WARNING! supply. Risk of injury, electric shock, fire, burns • Do not use multi-plug adapters and or damage to the appliance. extension cables.
• Please note that some of these spare • Disconnect the appliance from the mains parts are only available to professional electrical and water supplies. repairers, and that not all spare parts are • Cut off the mains electrical cable close to relevant for all models.
The rating plate reports the model name (A), product number (B), electrical ratings (C) and serial number (D). Mod. xxxxxxxxx Prod.No. 910000000 00 000V ~ 00Hz 0000 W 00000000 4. TECHNICAL DATA Dimension Width/ Height/ Total depth 59.6 cm /81.9 cm /55.3 cm Electrical connection Voltage 230-240 V...
Page 8
5.2 The appliance is equipped with ... 5.3 Unpacking WARNING! Use the gloves. WARNING! Remove all the packaging and the transit bolts before installing the appliance. 1. Put two packaging elements on the floor under the appliance. WARNING! It is strongly recommended that this action is carries out by two persons.
Page 9
3. Remove the protection from the bottom. 4. Return the appliance in vertical position and remove the socket protection. 5. Remove the power supply cable and the drain hose from the hose holders. It is possible to see water flowing from the drain hose.
7. Close the holes with the plastic caps you find in the user manual bag. Put the smallest cap F in upper hole and the two bigger caps G in lower holes. We recommend that you keep the packaging and the transit bolts for any movement of the appliance.
The appliance must be level and stable. CAUTION! Do not put cardboard, wood or equivalent materials below the appliance feet to adjust the level. 5.6 Hose and cable connection 1100 mm 1450 mm 1020 mm 760 mm 1360 mm 900 mm The inlet hose 1.
3. Connect the hose to the back of the appliance. Do not turn the inlet hose downwards, but turn it left or right depending on the position of your water tap. 4. Loosen the ring nut to fix it in the correct position.
Page 13
To a stand pipe with vent-hole Directly into a drain pipe at a height of not less Ø 40 mm than 60 cm (23.6”) and not more than 100 cm (39.3”). The end of the drain hose must always be ventilated , i.e.
Page 14
5.7 Building in This appliance has been designed to be built into the kitchen furniture. See the minimum recess min. 600 mm dimensions in the drawings. min. 560 mm min. 820 mm 16-22 mm 596 mm 553 mm If hoses run behind the appliance, make sure that nothing closes the small recess indicated with the measures 50 x 50 mm.
5.8 Installing anti-tilting device (Accessory) Install this accessory in case of risk of appliance tilting only. If the height of the counter is 820 mm or lower, you cannot install the anti-tilting device. 1. Remove the screws of the top cover on the rear of the appliance and install the anti-tilting device as shown in the drawing.
Page 16
Reversibility of the cupboard door Carry out the cupboard door reversibility before the appliance is built in completely. If the cupboard door has to be opened from left to right, invert the position of the hinge supports M with the magnetic plate N and lower plate O. Make sure that the plate with magnet is on the upper position.
Page 17
Set the position of the lower hole respecting dimensions and distances shown in the drawing 16-22 mm (449 mm). Countersink the holes. Ø 35 mm 12,5 - 14 mm 22±1,5 mm 595-598 mm Hinges To mount the hinges it is necessary to drill two holes (dia.
Page 18
Counter-magnet The appliance is pre set for a magnetic closure. For a correct closure: 1. Position the screw C and the counter-magnet D on the magnetic plate N. Lean the cupboard door against the screw until it leaves a mark. 2.
6. CONTROL PANEL 6.1 Control panel description 90° 1200 Eco 40-60 60° Time manager 40° 30° Delay Start 20° Cold Night Steam Plus Temp. Steam Soft Plus touch button and permanent Extra Rinse option The permanent options are set by Prewash touch button and permanent holding pressed the relative button for at Stain option...
Door locked indicator. Delay start indicator. The digital indicator can show: • Reset position ( • Programme duration (e. g. • Delay time (e. g. • Cycle end ( • Warning code (e.g. • Error indicator ( • Indication of total operating hours of the appliance. Refer to the 'Operating hours counter' section in the 'Settings' paragraph for more details.
7.3 Programme dial This helps to reduce creasing. The door stays locked. The drum turns regularly to For selecting the desired washing reduce creasing. You must drain the water programme. Refer to 'Programmes' chapter to unlock the door. for more details. As the programme is very quiet, it is suitable for use at night time when The position...
Page 22
7.8 Permanent Soft Plus are steady on. The drum performs smooth movements for about 30 minutes to keep the Set this option to optimise the fabric softener steam benefit. By touching any button the distribution and improve fabric softness. anti-crease movements stop and the door unlocks, the appliance proposes again the Recommended when you use fabric softener.
When you set a washing programme, the • : maximum. display shows the default duration and • : medium. dashes. • : minimum. Touch Time Manager button to reduce the programme duration according to your needs. The display shows the new programme In some appliances the programme duration and a number of dashes will duration is reduced without showing any...
Page 24
Programme Reference Maxi‐ Programme description Default tempera‐ spin speed (Type of load and level of soiling) ture load Temperature range 1200 rpm 3.0 kg Synthetic items or mixed fabric items. Normally soiled items. Synthetics 40 °C 60 °C - Cold 1200 rpm 2.0 kg Delicate fabrics such as acrylics, viscose and mixed fab‐...
Page 25
Programme Reference Maxi‐ Programme description Default tempera‐ spin speed (Type of load and level of soiling) ture load Temperature range 1200 rpm 7.0 kg All fabrics, except woollens and very delicate fabrics. Programme for rinsing and spinning the laundry. The default Rinse spin speed is the one used for cotton programmes.
Page 26
Programme Reference Maxi‐ Programme description Default tempera‐ spin speed (Type of load and level of soiling) ture load Temperature range 1200 rpm 2.0 kg Outdoor 1.0 kg Do not use fabric softener and make sure that 30 °C 40 °C - Cold there is no softener residue in the detergent dispenser.
Programme Reference Maxi‐ Programme description Default tempera‐ spin speed (Type of load and level of soiling) ture load Temperature range 1200 rpm 1.5 kg Machine washable wool, hand washable wool and other fabrics with «hand washing» care symbol Wool/Silk 40 °C 40 °C - Cold According to UK Ecodesign for Energy-Related Products and Energy Information Regulations and to the EU Ecodesign Regulation 2019/2023 and the EU Energy Label Regulation 2019/2014, this programme at 40 °C is able...
Programme Universal Liquid Univer‐ Liquid for col‐ Delicates Special oureds woollens powder 1) Rapid 14min ▲ ▲ Sport ▲ ▲ ▲ Outdoor ▲ ▲ Denim ▲ ▲ ▲ Wool/Silk ▲ ▲ At temperature higher than 60 °C the use of powder detergent is recommended. ▲...
seconds after the switching on. After 1. Switch the appliance on by pressing these 10 seconds, the key combination On/Off button. activates and deactivates the acoustic 2. Turn the programme knob to the signals). Synthetics programme (3rd position 4. After 3 seconds the total hours operated clockwise).
Always follow the instructions that you find on the packaging of the detergent products, but we recommend that you do not exceed the maximum indicated level ). This quantity will however guarantee the best washing results. After a washing cycle, if necessary, remove any detergent residue from the detergent dispenser.
• Do not exceed to liquid detergent dose The related indicator stops flashing and stays indicated on the flap. • Do not set the prewash phase. The programme starts, the door is locked. • Do not set the delay start function. The display shows the indicator and the 5.
11.10 Cancelling a running Changing the delay start after the programme countdown has started 1. Press the button On/Off to cancel the To change the delay start: programme and to deactivate the appliance. 1. Touch the Start/Pause button to 2. Press the button On/Off again to activate pause the appliance.
signals operate (if they are active). The The option indicator Rinse Hold display shows disappears. The indicator of the Start/Pause button goes off. If you have set Quiet and the spin speed is not changed, when you press The door unlocks and the indicator goes off.
12. HINTS AND TIPS WARNING! Refer to Safety chapters. 12.1 The laundry load • Divide the laundry into: white, coloured, synthetics, delicates and wool. • Follow the washing instructions on the laundry care labels. • Empty pockets and unfold the items. •...
• Use only detergents and other treatments • inadequate rinsing, specially made for washing machines. • a greater impact for the environment. First, follow these generic rules: 12.4 Savings tips – powder detergents (also tablets and single-dose detergents) for all types of To save water, energy and detergent we fabric, excluding delicate.
After each cycle, keep the door and the CAUTION! detergent dispenser slightly open to get air circulation and dry the humidity inside the Do not clean the metal surfaces with appliance: this will prevent mildew and chlorine-based detergent. odours. 13.4 Descaling If the appliance is not used for a long time: close the water tap and unplug the appliance.
Occasionally, at the end of a cycle the display may show the icon : this is a recommendation to perform the “drum cleaning”. Once the drum cleaning has been performed, the icon disappears. 13.8 Cleaning the detergent dispenser Clean it when needed, using ammonia cream To prevent possible deposits of dried cleanser agent without scratching the seal detergent or clotted fabric softener and/or...
13.9 Cleaning the drain pump filter the recess. Use a small brush to clean the recess. WARNING! Disconnect the mains plug from the mains socket. Regularly check the drain pump filter and make sure that it is clean. Clean the drain pump if: •...
Page 40
2. Place a suitable bowl below the drain pump access to collect the water that flows out. Always keep a rag nearby to dry up any water spillages when removing the filter. 180˚ 3. Turn the filter 180 degrees in anti-clockwise direction to open it, without removing.
Page 41
7. If it is necessary, remove fluff and objects from the filter recess. Make sure that the impeller of the pump can rotate. If it does not rotate, contact the Authorised Service Centre. 8. Clean the filter under the water tap. 9.
When you drain the water with the emergency drain procedure, you must activate the drain system again: 1. Put 2 litres of water in the main wash compartment of the detergent dispenser. 2. Start the programme to drain the water. 13.10 Cleaning the inlet hose and remove any deposit, collected over the time.
WARNING! Make sure that the temperature is higher than 0 °C before you use the appliance again. The manufacturer is not responsible for damages caused by low temperatures. 14. TROUBLESHOOTING WARNING! Refer to Safety chapters. 14.1 Alarm Codes and Possible failures The appliance does not start or it stops during operation.
Page 44
• Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this infor‐ The appliance does not fill mation, contact your local water authority. with water properly. •...
Page 45
Problem Possible solution • Set the spin programme. • Make sure that the drain filter is not clogged. Clean the filter, if necessary. Re‐ The spin phase does not op‐ erate or the washing cycle fer to "Care and cleaning". lasts longer than usual.
14.2 Emergency door opening To open the door, proceed as follows: 1. Press the On/Off button to switch the In case of power failure or functioning failure appliance off. the appliance door remains locked. The 2. Disconnect the mains plug from the washing programme continues when the mains socket.
Page 47
The QR codes on the EU and UK energy labels supplied with the appliance provide a web link to the information related to the performance of the appliance. For the energy label with the EU flag, it is also possible to find the information in the EU EPREL database using the link https://eprel.ec.europa.eu and the model name and product number that you find on the rating plate of the appliance.
Power consumption in different modes Off (W) Stand-by (W) Delay start (W) 0.50 0.50 4.00 Time to Off/Standby mode is 15 minutes maximum. 15.4 Common programmes These values are indicative only. Programme rpm 1) Litres hh:mm °C Cottons 1.900 85.0 03:25 53.00 85.0...
Need help?
Do you have a question about the E772F402BI and is the answer not in the manual?
Questions and answers