Related Manuals for GROLAB HW01
Summary of Contents for GROLAB HW01
- Page 1 GL-MN-0019-RV.01 ® CO2 Compact Sensor 2000ppm (HW01 - prototype version - dra�) INSTALLATION MANUAL www.opengrow.pt © 2022 Open Grow, LDA. All rights reserved.
-
Page 2: Table Of Contents
TABLE OF CONTENTS 1. SAFETY 2. SPECIFICATIONS 3. DESCRIPTION 4. COMPONENTS 5. INSTALLATION 6. TROUBLESHOOT 7. MAINTENANCE 8. SAFETY INSTRUCTIONS 9. WARRANTY 10. COMPLIANCE... -
Page 3: Safety
1. SAFETY General guidelines The following general safety guidelines are provided to help to ensure your own personal safety and protect your device from poten�al damage. •Do not a�empt to service the device. For some devices with a user-replaceable ba�ery, please read and follow the instruc�ons provided by the installa- �on manual. - Page 4 •The device must be protected from environmental extremes during storage as well as a�er installa�on. Ingress of dust and moisture must be prevented. Hea�ng of the room may be necessary to prevent any incidence of humidity during storage or before commissioning.
-
Page 5: Specifications
2. SPECIFICATIONS Hardware Version HW01 Dimensions 59 mm x 30mm x 18mm Weight (w/ 2m cable) Exterior Casing: Plastic Colors: White Operating Conditions 14°F to 140°F (-10°C to 60°C) 0 to 95% RH, non-condensing Expected Service Life >3 years Supply Voltage... - Page 6 Connector RJ-12 (6p6c) Includes 1 x GroLab CO2 Compact Sensor - 2000ppm w/2m cable 1 x GroLab Sensor Programmer 1 x GroLab programming cable Warranty 3-years limited hardware warranty RS-485 Speci cations TIA/EIA RS-485 compliant over full supply range ESD protection on the bus pins IEC 61000-4-2 ±12 kV contact discharge...
-
Page 7: Description
PowerBot Mul�-sensor connec�on outlet (2). TEMP/HUMI FIRMWARE CO2 SENSOR What is in the box • 1 x GroLab CO2 Compact Sensor - 2000ppm w/2m cable; • 1 x GroLab Sensor Programmer; • 1 x GroLab programming cable; • Installa�on manual. -
Page 8: Components
4. COMPONENTS GroLab CO2 Compact Sensor - 2000ppm GroLab Sensor Programmer Type-B USB cable (for programmer) -
Page 9: Installation
5. INSTALLATION Ini�al assembly Connect the CO2 Combined sensor (1) to the module’s outlet (2). TEMP/HUMI FIRMWARE CO2 SENSOR Place the sensor at the height of the plants where you could monitor the environmental state of the growing area correctly. Never positon the sensor too close to a light source, wet it, or put it in high (90%~100%) this can damage your sensor. -
Page 10: Troubleshoot
6. TROUBLESHOOT Symptom Possible Cause Possible Solu�on The combined CO2 1) Bad connec�on Re-plug your sensor sensor is plugged on between your sensor and make sure you see PowerBot but I cannot and PowerBot. a yellow blinking LED see any values. inside every seconds. -
Page 11: Maintenance
7. MAINTENANCE As the unit is essen�ally maintenance-free, ensuring maintenance limited periodically that it is free from dust or other residues. The service life of the CO2 Combined Sensor should be in excess of three years if operated within specifica�on. -
Page 12: Safety Instructions
8. SAFETY INSTRUCTIONS 3 The following general safety guidelines are provided to help ensure your own personal safety and protect your product from poten�al damage. •Do not a�empt to service the product and never disassemble the product. For some products with a user replaceable ba�ery, please read and follow the instruc�ons provided by the installa�on manual. -
Page 13: Warranty
9. WARRANTY General terms The warranty set forth below is given by Open Grow, Lda. (from now on, will be referred to as OPEN GROW). This warranty is only effec�ve upon presenta�on of the proof of purchase. EXCEPT AS EXPRESSLY SET FORTH IN THIS WARRANTY, OPEN GROW MAKES NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. - Page 14 Limita�on of warranty OPEN GROW warrants that the product under normal use is free from material defects in materials and workmanship during the warranty period if the product is used and serviced in accordance with the user manual and other documenta�on provided to the purchaser at the �me of purchase (or as amended from �me to �me).
- Page 15 Performance of the warranty If any defect occurs, OPEN GROW’s sole obliga�on shall be to repair or replace the product free of charge provided it is returned to OPEN GROW a�er-sales department during the warranty period. Such repair or replacement will only be rendered by OPEN GROW at an authorized OPEN GROW repair sta�on.
-
Page 16: Compliance
10. COMPLIANCE This symbol on the product or packaging means that according to local laws and regula�ons this product should not be disposed of in the household waste but sent for recycling. Please take it to a collec�on point designated by your local authori�es once it has reached the end of its life, some will accept products for free. - Page 17 NOTES...
- Page 18 ® GL-MN-0019-RV.01 Specifica�ons are subject to change without no�ce. GroLab is a registered trademark of Open Grow, LDA. Other brands and product names are trademarks or registered trademarks of their respec�ve holders. No part of the specifica�ons may be reproduced in any form or by any means or used to make any deriva�ve such as transla�on, transforma�on, or adapta�on without...
Need help?
Do you have a question about the HW01 and is the answer not in the manual?
Questions and answers