Power Stroke Ibanez Owner's Manual

OWNER'S MANUAL
Safety Information
●
Do not expose the device to liquids or moisture.
●
Clean only with a dry cloth.
●
Do not use near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers).
●
Do not defeat the safety purpose of the polarized or grounding-type plug.
●
Protect the power cord and pedal cables from being walked on or pinched.
●
Only use the original attachments and accessories specified by Ibanez.
●
During lightning storms or when unused for long periods of time, please unplug.
●
Do not attempt to service the device by yourself, as opening or removing cover may expose you to
dangerous voltage or another hazard.
●
Servicing is required when the unit has been damaged in any way, such as a power cord or plug is
damaged, liquid has been spilled or objects have fallen into the unit, the unit has been exposed to rain
or moisture, does not operate normally, or has been dropped.
●
Never push any object into the slots or openings on your unit enclosure.
●
When connected to a power outlet, power is always flowing into your unit. To totally disconnect power,
unplug the power cord.
Operation
DC Power input
Needs DC15-25V. Connect to the included AC/DC adapter. We have tested the
operation with the included adapter. We cannot guarantee operation with other
adapters.
Power output port 1-3
Each 2.1mm jack supplies 9V/500mA (max.).
Power output port 4-5
Adjustable voltage ports. Each 2.1mm
jack supplies at the following toggle switch
positions.
●
Up: 18V/150mA (max.)
●
Middle: 12V/225mA (max.)
●
Down: 9V/300mA (max.)
Power output port 6
2.1mm jack supplies 9V/300mA (max.).
LED Indicator
A) Off: No DC cable connection.
B) Green: A DC cable is connected and
the output works properly.
C) Green flash: Connection has an error.
(Error: e.g., short, overload)
●
The polarity of all the ports are center-negative.
●
Make sure the power supply voltage and current consumption (or total current consumption in case of
daisy-chain connection) of the connected devices and make sure the current consumption will not
exceed the maximum output current of each port.
●
Current doubler connection for a long time is not recommended because one port could be overloaded,
in which case the surface of the Power Stoke enclosure could get too hot.
Bundled items
●
1 × AC/DC adapter (Input: AC100-240V, Output: DC15V)
●
1 × IEC power cord
●
3 × Ibanez DCT twisted DC cable (8"/20cm)
●
3 × Ibanez DCT twisted DC cable (16"/40cm)
●
4 × 3M Dual Lock fastener tape
TM
●
4 × rubber foot
Specification
●
15-24V DC input with anti-reverse connection
●
Full-isolated 6 output ports
●
3 × 9V/500mA port
●
2 × adjustable voltage port (9V/300mA, 12V/225mA, 18V/150mA)
●
1 × 9V/300mA port
●
Max. output power: 21.6W in total
●
Dimensions: 92mm(L) x 88mm(W) x 29mm(H), 3.6"(L) x 3.5"(W) x 1.2"(H)
●
Weight: 180g, 0.40 lbs
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determine by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of more of the following
measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC's FR Exposure guidelines, this equipment should be installed and
operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Notice
HOSHINO GAKKI CO., LTD.
No.22, 3-Chome, Shumoku-Cho,
Higashi-Ku, Nagoya, Aichi, JAPAN