Related Manuals for Homa FN1-340
Summary of Contents for Homa FN1-340
- Page 1 Dear Customer: Thank you very much for purchasing both upright larder FL1- 470 and upright freezer FN1-340 from Homa. You may connect FN1-340 and FL1-470 side by side with connection kit. 1.cgm...
- Page 2 1198mm Space dimensions required for FN1-340 and FL1-470 after connection. 1227mm 1310mm 2.cgm...
- Page 3 SBS Connection Kit Checklist 3.cgm 4.cgm 5.cgm 6.cgm Lower bar fixed iron X1 Lower bar decoration cover X1 Top decoration cover X1 Fixed iron X3 7.cgm screw （ B ） X4 decorative stripX1 screw （ A ） X8 9.cgm 8.cgm...
- Page 4 Preparations before installation 1. Cut off the power supply of the two units. 2. Make one of the refrigerators open to the left and another open the door to the right. Please refer to the user manual about the steps of how to reverse the door. 3.
- Page 5 Installation step 1. Use a screwdriver to remove the top door hinge cover and bottom screw cover at the lower bar. 10.cgm 2. Adjust the distance between the two refrigerators, install the fixed iron on the top with screw (A), but do not tighten the screws.
- Page 6 Installation step 3. Adjust the height by rotating the four adjusting feet at the bottom(two of which are shown in the figure), so that the fronts of the two refrigerators are aligned. 11.cgm 4. Adjust the distance between the two refrigerators, install the Lower bar fixed iron on the bottom with screw(A), but do not tighten the screws.
- Page 7 Installation step 5. If there is a rear panel support assembly installed on the back of the cabinet, remove it. 14.cgm 6. Adjust the distance between the two refrigerators, install the fixed iron on the back with screw(B), and tighten all the screws. 16.cgm 15.cgm...
- Page 8 Installation step 7. Install the decorative strip in the gap between the two refrigerators. 17.cgm 18.cgm 19.cgm...
- Page 9 Installation step 8. Install the top decoration cover on top of both refrigerators with screw(A). 20.cgm 21.cgm 9. Install the Lower bar decoration cover on the fixed iron, install it from top to bottom. 20.cgm 21.cgm...
- Page 10 Installation space requirements...
Need help?
Do you have a question about the FN1-340 and is the answer not in the manual?
Questions and answers
How to cancel the alarm in homa fn1-340